Muratec F-65 operating instructions Press ENTER. The LCD will show briefly

9 Enter an ITU-Tsubaddress for the box to which you want to send the docu- ment. The ITU-Tsubaddress can be up to 20 characters in length and can include any combination of numbers and the * and # symbols. Do not include other non-numerical characters.

In this example, we enter 6*54321#.

6*54321#_

10 Press ENTER. The LCD will show briefly:

Enter Password

_

Note: If you know that this ITU-Tsubaddress does not have an ITU-Tpass- word, skip to step 12.

11 Enter an appropriate ITU-Tpassword for the box. The ITU-Tpassword can be up to 20 characters in length and can include any combination of numbers and the * and # symbols. Do not include other non-numerical characters). In this example, we enter 1*23456#1.

1*23456#1_

Note: If you make a mistake, press CANCEL to back up, then enter the cor- rect number.

When the entry is complete, press ENTER.

12 If you want the transmission to begin immediately every time you press the key, press ENTER again and skip to step 15.

If you want to delay the transmission (perhaps to take advantage of lower

phone rates), press COM-OPTIONS,COM-OPTIONS,ENTER.

13 Instructways: your fax to carry out this delayed command in one of the following

Option 1: Perform the command once at a certain time on a certain day of the month (For example, “Do this at 5:05 PM on the 30th.”)

To select this option, use the numeric keypad to enter the date and time when the fax should perform the command:

Time : 30/17:05

Beyond the basics

Option 2: Perform the command at a certain time each day you press the key. (For example, “Do this at 5:05 PM today.”)

To select this option, use the numeric keypad to enter 0, 0 (i. e., 00), and then the time when the fax could perform the com- mand:

Time : 00/17:05

14 Press ENTER, ENTER.

15 The LCD now shows the next programmable one-touch key.

If you do not want to enter or change any other key’s programming, press STOP to return your machine to its usual standby mode.

If you do want to enter or change another key’s programming, go back to step 4.

2.35