•The amber pilot light (I) will come on from time to time during ironing.
•If you set the temperature control (A) to a lower setting after ironing at a high temperature, do not begin again before the amber pilot light (I) has come on and has gone out again. This is to prevent scorching on your garment.
Ironing without steam
- Set the steam control (B) to position O (= no steam) (fig. 2).
• To switch on the iron, refer to paragraph “Setting the temperature”.
Steam-ironing (see table)
•Ensure that there is enough water in the water reservoir. - Set the steam control (fig. 5):
No steam setting (O) for temperature settings MIN to 2. Steam setting (q) for temperature settings 2 to 3.
Maximum steam setting (w) for temperature settings 3 to MAX.
•Water may leak from the soleplate if a too low temperature (2 and lower) has been selected.
•To switch on the iron, refer to paragraph “Setting the temperature”.
Extra Steam 0 (only type HI 312) (see table)
•This feature provides extra steam to remove stubborn creases.
•Apply Extra Steam only at 3 to MAX temperature setting.
-Set the steam control to the highest steam position w (fig. 6).
-Press and hold the Extra Steam button 0 for a few seconds (max. 5 seconds) (fig. 7). Then release the button.
-Wait at least 1 minute before applying Extra Steam again. This prevents water dripping from the soleplate.
Spraying T (see table)
-To remove stubborn creases at any temperature, push the spray button T (D) a couple of times to damp the laundry (fig. 8).
• Ensure that there is enough water in the water reservoir.
8