Bosch Appliances WTXD5500UC manual Program selection, Automatic programs, Options

Program selection

For optimum drying results your dryer offers several program groups and additional options.

Select the required drying program from the program table according to the examples (see page 19).

Automatic programs

There are automatic programs for different types of textiles. (regular/cotton or permanent press).

regular/cotton

Time	programs					Indicator	of	program
						sequence
						The dryer uses an electronic
						scanning system for all programs
						except the time programs .
						A￿moisture sensor continuously
						checks the moisture in the laundry.
						Drying ends	automatically as soon
						as the selected degree of dryness
						has been reached.
Time programs run for a specific						The drum continues to rotate at
time (20,	40,		60 minutes).			specific intervals for one hour to
In the "air fluff" stage				the	dryer	prevent creasing.
						runs
on ambient		air	without	a	heat	The current	degree	of drying and
supply for		20	minutes.
						the level reached during the
Options						program sequence		is indicated

via￿indicator lights (drying, damp dry, regular dry, wrinkle block/ finished).

delicates

Press the "delicates" button for

temperature

sensitive

textiles.

Observe

the

care information

or

i

permanent

press

symbols

on

the

textiles.

The

temperature of the drying process is

reduced, the drying time is

extended.

signal

Your dryer outputs

different

signals,

if the "signal" button is pressed.

signal

type

Start

Short tone

The program sequence

of

End

Sequence

of

short

tones

automatic

programs is

controlled

via sensors. The duration of the

Mal￿operation

Sequence

of

long

tones

program depends on the measured

Warning

of

Sequence

of

long

tones

degree of

moisture in

the laundry

malfunction

and on the selected degree of

. i

The

signal

dryness (e.g.￿damp dry

or extra dry)

•Warning

of

malfunction"

is

active in

any

case.

If the indicator light "antiCrease" illuminates when the program selector is in off-Position - turn off the circuit breaker and call for customer service!

18