If the door hinges are to be changed over, please contact your dealer or our customer service team (seepage25).
7
& #& '# ) ) #)
0 !!
The dryer door is delivered with hinges on the right. If required, the
& &+$$" " ("'" door hinges can be switched to the left side.
1 !!
#$
The size of the installation area depends on the dimensions of the
dryer. Ensure that there is adequate%
room for the swivel range of the door!
0 !!
&
Clearances
t
Minimum Installation
Install the dryer and level side toside and front to back. Useabubble level. Never remove the height7adjustable feet!
"
The installation surface for the dryer must be clean, level and firm. Do not install the appliance on carpets!
Compensate for uneven floors with If installing the dryer in a closet,
the height7adjustable feet.observe the minimum distances according to the following table:
)'
$"
14 & 4
1 &
0 !! 1 0 !!
4 !!
1 00 !! 1010*
t
mnn
- with other fuel7burning appliance in the same closet.
The installation room must be well ventilated, otherwise the dryer will operate below optimum performance.
Do not operate the dryer at temperatures above 104°F (40°C) and below 41°F (5°C). Low temperatures affect the automatic program sequence and may prolong the drying times.
- If the dryer is installed in a sma room, the doors of the room must be fitted with vents of aspecified minimum size.
- in cupboards with lockable doors or in alcoves.
- Additional distances facilitate installation and service.
- in rooms which may contain gas or other fuels,
- Additional distances reduce noise transmission.
Do not install the dryer: - outdoors,
- in an environment with dripping water,
- near flammable materials,
- in rooms which are at risk of frost,
If installed in a garage, the dryer - Depending on the location of
must be installed on athe exhaust air connection, an
substantial platform at least 18 additional minimum distance of
inches above the floor to reduce 5½ inch (14 cm) must be
the liklihood of ignitingprovided on this side for
flammable vapors and bepipes/brackets (see page 9).
located or protected so it cannot - Distances above the indicated
be damaged by a moving vehicle minimum dimensions reduce the risk of mold formation behind the appliance.
Important information concerning minimum distances:
Installation location |
| WARNING! |
|
| |
WARNING! |
|
|
|
| |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|