Husqvarna FS4800D manuel dutilisation 2M. V-BELTS Set of 4, 3 Groove, 2N. Gearbox Pulley

3-2M. V-BELTS: Set of 4, 3 Groove

3-2N. GEARBOX PULLEY:

3-2O. GEARBOX SHIFT LEVER: Use to change output speed of the ENGINE GEARBOX (3-2A). Three- Speeds and two Neutral positions are available. GEARBOX SHIFT LEVER positions (1, 2, and 3) are color coded to match, among others, Gearbox Range / Blade RPM decal. GEARBOX SHIFT LEVER Operation:

1)Turn ENGINE START SWITCH (1H) to OFF (“0”) position. Always turn Engine OFF before shifting gearbox!

2)Verify that pulley size, flange size, and blade shaft speed are correct for the blade size being mounted.

WARNING: Serious injury can occur to the operator or people in the work area if the rotational speed (n/min) of the DIAMOND BLADE (2E) exceeds the maximum speed (n/ min) marked on the DIAMOND BLADE (2E).

3)Lift GEARBOX DETENT KNOB (3-2P) and twist to hold in “OPEN” position.

4)Move GEARBOX SHIFT LEVER (3-2O) to required gear. A slight “rocking motion” of the gearbox output shaft (or BLADE SHAFT) may improve shifting.

5)Twist and lower GEARBOX DETENT KNOB (3-2P) back to original “LOCKED” position.

3-2P. GEARBOX DETENT KNOB: Locks GEARBOX SHIFT LEVER (3-2O) in position. See GEARBOX SHIFT LEVER (3-2O) for operation.

FIGURE 4

4A. BLADESHAFT BEARING SEALS

4B. FRONT WHEEL BEARINGS

4C. FRONT AXLE PIVOT BEARINGS

4D. HYDRAULIC CYLINDER PIVOT PIN

4E. REAR AXLE

4F. HYDRAULIC WHEEL MOTOR

4G. RAISE LOWER CYLINDER

4H. LINEAR ACTUATOR

48

FIGURE 5

5A. AIR FILTER ASSEMBLY: Includes

a)Housing

b)Cover

c)Primary Outer Element: Clean or replace when AIR RESTRICTION INDICATOR (1N) shows the RED warning.

d)Inner Safety Element: DO NOT CLEAN this filter element. Replace 1 time per year or if it becomes damaged.

5B. ENGINE OIL DIPSTICK: Check Engine Oil Level Here. Dipstick indicates oil level. See engine opera- tion manual for more information.

5C. ENGINE OIL FILL: Fill engine with recommended oil at this location. Use SAE 15W40 API Class CF, CF-4, CG-4, or CI-4 engine oil. See engine operation manual for more information.

5D. ENGINE OIL FILTER: See engine operation manual for more information.

5E. FUEL TANK FILL: Fill the fuel tank at this location.

5F. FUEL FILTER:

5G. AIR FILTER RAIN CAP

5H. D.C. (direct current) LIFT PUMP: Raises and lowers the saw.

5I. HYDRAULIC RESERVOIR FILL: Fill and check hydraulic system fluid here.

5J. HYDRAULIC OIL RESERVOIR: 1.5 Quart Capacity

(1.42 Liter)

5K. HYDRAULIC FILTER: Filters hydraulic system fluid.

5L. ----