Husqvarna FS4800D manuel dutilisation Do not Operate Engine with Shields or Guards Removed

5M.	----
5N.	----
5O.	----
5P.	----

FIGURE 6

6A. LIFTING BAIL: The saw can be lifted only from this point. Do NOT lift the saw from any other location.

6B. ----

6C. BELT GUARDS AND SHIELDS: Protects engine, guards, drives, and cooling fan. Do not remove during operation, or when engine is running!

DO NOT OPERATE ENGINE WITH SHIELDS OR GUARDS REMOVED!

6D. FRONT GUIDE: Use to locate the path of the diamond blade on the cutting line.

6E. ENGINE HOOD: Protects engine, cooling fan, beltdrives and pulleys. The ENGINE HOOD is a guard, and must be latched in the lowered position before starting engine and operating saw. Open ENGINE HOOD by rotating the two HOOD LATCHES (3-1D, 3-2D) Counter-Clockwise 180 degrees. Swing upward and secure using HOOD SUPPORT (6H).

6F. REAR GUIDE: Use to locate the path of the diamond blade on the cutting line.

6G. HANDLEBARS: Used to maneuver the saw. Not to be used to lift the saw. (Same as 1B)

6H. HOOD SUPPORT: Latch to secure the hood in the open position. Always lower and secure the hood before starting the engine or operating the machine.

6I. RADIATOR COOLANT FILL: Fill radiator from this point. Warning: Avoid injury! Built-up pressure may cause explosive release of coolant when the radiator cap is removed. Shut off the engine and allow to cool. Do not remove the cap unless the radiator and the engine are cool enough to touch with bare hands. Slowly loosen the cap to the first stop to release all pressure. Then remove the cap. Replace cap if damaged.

6J. TRANSMISSION BYPASS VALVE (Front Pivot Model Only): Turn counter clockwise to open. Turn clockwise to close. Open to allow pushing of concrete saw.

6K. HYDROSTATIC TRANSMISSION PUMP.

6L. ALTERNATOR: See Yanmar for replacements.

6M. ALTERNATOR / WATERPUMP BELT: Self

Tensioning. See Yanmar for replacements.

FIGURE 7

7A. PARKING BRAKE (CE Models or Rear Pivot models-If Equipped): Holds machine in parked position on a slope of 10 degrees or less. PARKING BRAKE (7A) located on left hand side of machine, at rear wheel (See FIG 7).

Operation:

1)Stop machine, turn off engine.

2)To apply: Stand behind machine, push PARKING BRAKE LEVER (7A) forward (Toward front of machine).

3)To disengage: Stand behind machine, pull PARKING BRAKE LEVER (7A) backwards toward rear of machine.

CAUTION: Disengage PARKING BRAKE LEVER (7A) before fully engaging SPEED CONTROL LEVER (7B), else machine could be damaged.

49