INSTALLATION INSTRUCTIONS
– Split system air conditioner –
This air conditioner uses the new refrigerant R410A.
DECLARATION OF CONFORMITY
This product is marked | as it satisfies Directives: |
–Low voltage no. 73/23 EEC and 93/68 EEC.
–Electromagnetic compatibility no. 89/336 ECC, 92/31 EEC
and 93/68 EEC.
This declaration will become void in case of misuse and/or non observance though partial of manufacturer's installation and/or operating instructions.
COOLING ONLY MODELS
OPERATING LIMITS |
|
|
Maximum conditions |
|
|
Outdoor temperature | : | 43°C D.B. |
Room temperature | : | 32°C D.B. / 23°C W.B. |
Minimum conditions |
|
|
Outdoor temperature | : | 19°C D.B. |
Room temperature | : | 19°C D.B. / 14°C W.B. |
HEAT PUMP MODELS
OPERATING LIMITS
Cooling Maximum conditions
Outdoor temperature | : | 43°C D.B. |
Room temperature | : 32°C D.B. / 23°C W.B. | |
Cooling Minimum conditions | ||
Outdoor temperature | : | 19°C D.B. |
Room temperature | : 19°C D.B. / 14°C W.B. | |
Heating Maximum conditions | ||
Outdoor temperature | : 24°C D.B. / 18°C W.B. | |
Room temperature | : | 27°C D.B. |
Heating Minimum conditions
Outdoor temperature :
ACCESSORIES SUPPLIED WITH THE UNIT
PARTS | FIGURE | Q.TY | PARTS | FIGURE | Q.TY | |
RAWL PLUG |
| 2 | TAPPING |
| 2 | |
| SCREW 3,5 X 13 |
| ||||
|
|
|
|
| ||
RECEIVER WITH |
| 1 | DRAIN |
|
| 1 |
CABLE (5 mt) |
| ELBOW * |
| |||
|
|
|
| |||
REMOTE |
| 1 | DRAIN |
|
| 2 |
CONTROL UNIT |
| CAP | * |
| ||
|
|
|
| |||
|
|
|
|
| ||
AAA ALKALINE |
| 2 | HEX |
|
| 1 |
BATTERY |
| WRENCH * |
| |||
|
|
|
| |||
TAPPING |
| 2 | * Outdoor unit |
|
| |
SCREW 4 X 30 |
|
|
| |||
37.4196.087.0
Model Combinations
Combine indoor and outdoor units only as listed below.
| COOLING ONLY MODELS | |
Indoor Units |
| Outdoor Units |
| ||
| ||
| ||
| ||
| ||
|
| |
| ||
| HEAT PUMP MODEL | |
Indoor Units |
| Outdoor Units |
| ||
| ||
| ||
| ||
| ||
| ||
WARNING
Read the yellow instruction sheet attached to the outdoor units.
Tools required for installation (not supplied)
1. Standard screwdriver | 19. Hammer |
2. Phillips head screwdriver | 10. Drill |
3. Knife or wire stripper | 11. Tube cutter |
4. Tape measure | 12. Tube flaring tool |
5. Level | 13. Torque wrench |
6. Sabre saw or key hole saw | 14. Adjustable wrench |
7. Hacksaw | 15. Reamer (for reburring) |
8. Core bits ø 5 | 16. Hex. key |
|
|
02/2006 |
|
EG
I
F
D
E
P
GR