Balcar R410A service manual How to use attached installation pattern, 126, Model name 561CT, 801CT

RAV-SM561, 801CT-E

RAV-SM1101, 1401CT-E

2 SELECTION OF INSTALLATION PLACE

External view

REQUIREMENT

Strictly comply with the following rules to prevent damage of the indoor units and human injury.

•Do not put a heavy article on the indoor unit. (Even units are packaged)

•Carry in the indoor unit as it is packaged if possible. If carrying in the indoor unit unpacked by necessity, be sure to use buffering cloth, etc. to not damage the unit.

•Do not apply force to the other parts (refrigerant pipe, drain pan, foamed parts, or resin parts, etc.).

•Carry the package by two or more persons, and do not bundle it with PP band at positions other than specified.

			Upper pipe draw-out port (Knockout hole)
	128	Power supply cable take-in port (Knockout)		216
		Remote controller cable take- in port
	84	(Knockout hole)		110 76
320 170	position)	53	70
	(Hanging	Left drain size	Refrigerant pipe
			(Liquid side ØC)

130 50

210

167

105

680

Pipe draw-out port (Knockout hole)

Drain port VP20

(Inner dia. Ø26, hose attached)

114

	41
(Liquid pipe)	(Gas pipe)
200	216

			B (Hanging position)
			Refrigerant pipe (Gas side ØD)	75
				146
Hanging bolt	Ceiling surface
Within 50
		Unit

A

Drain pipe connecting port 97

		Remote controller cable take- in port
	347	Power supply cable take-in port (Knockout hole)
262			Remote controller cable take- in port
	90	32	(Knockout hole)		32
135			92	84
145					171
	Outside air take-in port
	(Duct sold separately)(Knockout hole Ø92)

Pipe hole on wall (Ø100 hole) Drain left pipe draw-out port (Knockout hole)

Wireless sensor mounting section

Model name	A	B	C	D
561CT	910	855	Ø6.4	Ø12.7
801CT	1180	1125	Ø9.5	Ø15.9
1101CT to 1401CT	1595	1540

Considering pipe/wire connecting work inside the ceiling after the indoor unit has been hanged, select an installation place and determine piping direction.

•If the ceiling has already been set before hanging the main unit, prepare refrigerant pipe, drain pipe, indoor connecting wire, remote controller cord, etc. up to the place where pipe and wire can be connected.

•Check the size of the indoor unit, and match the indoor unit size using the attached installation pattern.

How to use attached installation pattern

Using the pattern, positioning of the hanging bolt and pipe hole can be performed.

*As an error to some degree may generate on the pattern size due to temperature and humidity, be sure to confirm the size.

Installation pattern

Ceiling surface

Wall face

– 126 –