Balcar R410A service manual 153, Operation Section Display Section

HOW TO SET THE FAN SPEED

Operation Section

Display Section

All indicators are shown in the right and the lower figures for the explanation.

Only selected contents are display in actual operation.

•When turning on the leakage breaker at the first time 3 minutes later, [SET DATA] flashes about for 1 minute on the display part of the remote controller. While this display is flashing, the model is being automatically confirmed. Accordingly, wait for 1 minute after [SET DATA] display has disappeared, and then use the remote controller.

ADR

ADR

SET

CL

ACLSENSOR

Display section

Operation section

Push each button to select a desired operation.

•The details of the operation needs to be set up once, afterward, the air conditioner can be used by pushing button only.

1

5

– 153 –

		1
2		5
		6
3		7
		8
4	ADR	9
		10

2

3

SET

CL

4

6

ADR

ACL SENSOR

7

1 Transmitting indication

Displayed while operating the switches of the remote controller.

2 Mode display

The selected operation mode is displayed.

3 Fan mode select display

The selected fan mode is displayed. (AUTO)

(HIGH) (MED.)

(LOW)

4 Filter display

If “FILTER ” is displayed, clean the air filter.

5 CHECK display

Displayed while the protective device works or a trouble occurs.

6 Set up temperature display

The selected set up temp. is displayed.

7 Flap position display

8 SWING display

Displayed during up/down movement of the flap.

9 Timer time display

Time of the timer is displayed.

(When a trouble occurs, the check code is displayed.)

10 Timer SETIN setup display

When pushing the Timer SET button, the display of the timer is selected in order of [OFF]

[OFF] repeat OFF timer [ON] No display.

1 Operation select button Selects desired operation mode.

2 Fan mode select button Selects a fan mode.

3 Timer set button

TIMER SET button is used when the timer is set up.

4 Check button

CHECK button is used for check operation. During normal operation, do not use this button.

5 Temperature set button

Adjusts required room temperature. Set required set temperature by

pushing or .

6 Start/Stop button

When the button is pushed, operation starts, and it stops by pushing the button again.

When the operation stops, the operation lamp and all displays disappear.

7 Filter reset button

Resets (Erases) “FILTER ” display.

OPTION :

Remote controller sensor

Usually the TEMP. sensor of the indoor unit measured a temperature. A temperature around the remote controller can also be measured.

For details, contact the dealer from which you have purchased the air conditioner.

RBC-AX22CE