Denon DN-C630 Starting Playback, Stopping Playback, PLAY/PAUSE and CUE Operations, Play and Pause

Page 12

9

POWER

 

COMPACT DISC PLAYER DN-C630

 

 

 

 

 

 

 

TIME

 

 

 

 

 

 

 

 

OPEN / CLOSE

 

 

 

 

 

 

 

 

 

PLAY

 

 

 

0%

 

 

 

 

TRACK

MODE

END MON INDEX

REPEAT

A-B

PITCH

PHONES

LEVEL

STOP

CUE

PLAY / PAUSE

 

 

 

 

 

 

 

 

 

 

 

SEARCH

 

PROG. IN

 

 

MIN MAX

 

 

 

 

 

 

 

 

 

 

 

 

PRESET

 

 

 

 

 

98,9

(2)Starting Playback

Start playback.

Press the PLAY/PAUSE button.

LitOff

PLAY / PAUSE

PLAY / PAUSE

CUE

8

Playback begins and the playback signals are output.

Flashing (indicates the playback position)

SINGLE

REMAIN

PITCH %

(3) Stopping Playback

When playback is stopped, the play finish mode set in step 2 above is set.

Playback can be stopped in the following ways:

STOP

Playback is interrupted and the stop mode is set.

FlashingLit

CUE

CUE

CUE

9

Playback is interrupted, the pickup returns to the play start position and the standby mode is set.

PLAY / PAUSE

PLAY / PAUSE

Flashing

Playback is interrupted and the pause mode is set at that point.

Sleep mode

The sleep mode is set if no operation is performed for 30 minutes in the standby, pause or manual search mode. When in the sleep mode, press the PLAY/PAUSE button to search for the position before the sleep mode was set and start playback. Press the CUE button to search for the position before the sleep mode was set and standby at that point.

ENGLISH

(4)PLAY/PAUSE and CUE Operations

The operation switches between playback and pause each time the PLAY/PAUSE button is pressed.

When the CUE button is pressed during playback, the pickup returns to the position at which playback was started.

The diagrams below show playback patterns when the PLAY/PAUSE and CUE buttons are pressed.

PLAY and PAUSE

PLAY/PAUSE

PLAY/PAUSE

 

button

button

 

pressed

pressed

PLAY/PAUSE button pressed

Position on disc

Section

Section

played

played

Pause mode set at this point

When the PLAY/PAUSE button is pressed, playback starts and proceeds as shown by the arrow on the diagram above.

If the PLAY/PAUSE button is pressed again during playback, the pause mode is set at that point. Press the PLAY/PAUSE button again to resume playback.

PLAY and CUE

PLAY/PAUSE

button CUE button pressed pressed

Position on disc

Section

played

Back Cue

When the CUE button is pressed after starting playback by pressing the PLAY/PAUSE button, the pickup returns to the position at which playback was started and prepares for the next playback.

Press the PLAY/PAUSE and CUE buttons alternately to start playback repeatedly from the same position.

This function is called “Back Cue”.

PLAY, PAUSE and CUE

PLAY/PAUSE

PLAY/PAUSE

 

button

button

PLAY/PAUSE

 

pressed

pressed

button

CUE

 

 

 

 

 

 

pressed

 

 

 

 

 

 

 

button pressed

 

 

 

 

 

 

 

Position on disc

 

 

Section

 

 

 

Section

 

 

 

 

 

 

 

 

 

played

 

 

 

played

 

If the pause mode is set and playback is then resumed, the position to which the pickup returns with the Back Cue function changes.

13

Image 12
Contents DN-C630 Class Laser Product Safety Instructions U i o English Deutsch Francais Español Svenska Main Features Super Liner Converter S.L.CContents Part Names and Functions Rear Panel Analog OUT Balanced connectors Remote connectorDisplay Window Repeat indicator Time mode indicatorsRemote Control Connections Opening and Closing the Disc Holder and Loading DiscsOpening and closing the disc holder Loading discsBasic Operation 4,5-2 Before Starting PlaybackStarting Playback Stopping PlaybackPLAY/PAUSE and CUE Operations Play and PauseHandy Operations Starting Playback from the Middle of a Track Manual SearchPlaying at a Different Speed Pitch Select the repeat mode Canceling the repeat mode during playbackPlaying Repeatedly Repeat Standby at the play start positionPlaying a Specific Section of the Disc A-B Repeat Repeat playProgrammed Playback Inputting the ProgramChanging the Program 5-3,5-4,6-1 Playing Programs2-3 Presetting Programs Change the preset setting Press the select knobCancel the preset mode Press the Play Mode button Input the programPreset Functions and Operations List of Preset FunctionsPresetting Procedure Enter the preset modeExit the preset mode Change the preset valuesDetailed Description of Preset Functions M. OFFCD-R no TOC on OFF Before Switching OFF the Power Precautions on handling compact discsPrecaution on storage Compact DiscsTroubleshooting SpecificationsHauptmerkmale SUPERLINEAR-KONVERTER S.L.CInstallation des Gerätes InhaltÜberprüfung des Kartoninhaltes VorsichtBezeichnung DER Teile UND Deren Funktionen Wahlschalter Suchlauftasten SearchPROG. Play ON/OFF-Taste PROG. IN-TasteDigital OUT UNBALANCED-Buchse Display-Fenster REPEAT-AnzeigeTime MODE-Anzeigen Play MODE-AnzeigenFernbedienungsanschlüsse Öffnen und Schließen der DiscfächerEinlegen der Discs Grundlegender Betrieb 4,5-2 Vor dem WiedergabestartStarten der Wiedergabe Stoppen der WiedergabePLAY/PAUSE und CUE Betriebe Play und PauseBequeme Bedienung Wiedergabe mit unterschiedlichen Geschwindigkeiten TonhöheAuffinden der Wiedergabe-Position Aufsuchen der Wiedergabe-StartpositionWiederholung der Wiedergabe Wiedergabe-Wiederholung Wählen Sie den Wiedergabemodus anWählen Sie den Wiederholungsmodus an Bereitschaft an der WiedergabestartpositionWiederholte Wiedergabe HinweisProgrammierte Wiedergabe Eingeben eines ProgrammsÄndern des Programms Wiedergabe von Programmen 2-3 Speichern von Programmen Gespeicherte Funktionen UND Betriebe Auflistung der Speicher-FunktionenSpeicherverfahren Geben Sie den Speichermodus einWählen Sie die zu speichernde Position an Ändern Sie die gespeicherten WerteDetaillierte Beschreibung der gespeicherten Funktionen CD-R no TOC on OFF VOR DEM Abschalten DES Stromes CD-PLATTENVorsichtsmaßnahmen zur Handhabung von CD-Platten Vorsichtsmaßnahmen zur Aufbewahrung von CD-PlattenFehlersuche Technische DatenAllgemeines AudioteilPrincipales Caracteristiques Convertisseur SUPER-LINEAIRE S.L.CInstallation du lecteur Table DES MatieresPoints de vérification Nomenclature ET Fonctions Commandes Level L/R niveau G/D Connecteur Remote télécommandeTouches Search Touche PROG. in entrée de programmeIndicateurs Time Mode mode de temps Indicateurs Play Mode mode de lectureFenêtre d’affichage Voyant Repeat Affichage du no. de plageConnexions DE Telecommande Ouverture et fermeture du réceptacle de disqueChargement de disques Fonctionnement DE Base 4,5-2 Avant de commencer la lectureDémarrage de la lecture Arrêt de la lecturePLAY/PAUSE lecture/pause et CUE repérage Play lecture et PauseOperations Pratiques Lecture à une vitesse différente PitchRemarque Sélectionner le mode de répétition Annulation du mode de répétition pendant la lectureLecture répétitive Répétition Attente en position de départ de lectureLecture d’une section spécifique du disque Répétée de A-B Lecture répétée de A-BLecture Programmee Introduction de programmesChangement de programme Lecture de programmes Annulation du mode préréglé 2-3 Préréglage des programmesNota Introduction de programmesFonctions Prereglees ET Fonctionnement Liste des fonctions prérégléesEntrer en mode préréglé Quitter le mode prérégléProcédure de préréglage Modifier les valeurs prérégléesDescription détaillée des fonctions préréglées Remarque Avant D’ETEINDRE L’APPAREIL Disques CompactsPrécautions de manipulation de disques compacts Précautions de conservationDepistage DES Pannes Caracteristiques TechniquesCaracterísticas Principales Indice Comprobación del contenido de la caja de embalajeInstalación de la unidad PrecauciónNombre Y Función DE LAS Piezas Botón PROG. @0 Control Deslizante de VelocidadTomas Analog OUT sin balancear Controles Level L/R de nivel izquierdo y derechoIndicadores de Time Mode modo tiempo Indicadores de Play Mode modo reproducciónPantalla de visualización Indicación Repeat Visualización de número de pistaConexiones Para Control Remoto Apertura Y Cierre DEL Portadisco Y Carga DE DiscosApertura y cierre del portadisco Carga de discosManejo Básico 4,5-2 Antes de comenzar la reproducciónComienzo de la reproducción Parada de la reproducciónOperaciones de PLAY/PAUSE y CUE Play y Pause reproducción y pausaOperaciones Útiles Reproducción a una velocidad distinta TonoReproducción repetida Repetida Reproducción repetida Determinar la posición de comienzo de reproducción punto aAjustar el punto a Determinar la posición de comienzo de reproducción punto BReproducción Programada Introducción del programaCambio del programa Reproducción de programas Cancelar el modo de preajuste 2-3 Preajuste de programasIntroducir el programa Comienza la reproducción programadaFunciones Y Operaciones DE Preajuste Lista de las funciones de PreajusteProcedimiento de Preajuste Introducir el modo de preajusteCambiar los valores de preajuste Salir del modo de preajusteDescripción Detallada de las Funciones de Preajuste CD-R no TOC on OFF Antes DE Desconectar LA Alimentacion a LA Unidad LOS Discos CompactosPrecauciones relativas al almacenamiento de los discos PrecaucionLocalizacion DE Fallos EspecificacionesHuvudegenskaper Super Linear Converter S.L.CInnehållsförteckning Kontroll av innehålletMontering av enheten FörsiktigtDelarnas Namn OCH Funktioner Söktangenter Search Programmeringstangent PROG.@0 Tonhöjdsreglage Baksida Analoga utgångar, symmetriskaDisplayfönster Repeteringsindikator Repeat TidslägesindikatorerIndikatorer för avspelningssätt SpårnummerdisplayFjärrstyrningsanslutningar ÖPPNING/STÄNGNING AV SKIVHÅLLAREN, HUR MAN Lägger I SkivorÖppna/stänga skivhållaren Lägga i en skivaGrundbruk 4,5-2 Innan avspelningen startasStarta avspelningen Stoppa avspelningenAvspelning och Paus Avspelning och CUEPraktiska Funktioner Starta avspelningen mitt i ett spår manuell sökningÄndra avspelningens hastighet tonhöjdskontroll ObserveraRepeterad avspelning repetition Välj önskat avspelningssättVälj repetitionssätt Standby vid den punkt där avspelningen börjarAvspelning av ett särskilt avsnitt på skivan A-B repetition RepetitionsavspelningProgrammerad Avspelning ProgrammeringÄndra ett program Spela programmet 2-3 Förinställa program Förinställning AV Funktioner OCH Procedurer Förteckning över förinställningsfunktionerFörinställning Ändra förinställningspunkten102 Detaljerad förklaring av förinställningsfunktionerna103 Innan Strömmen Slås AV Compact DISC-SKIVORFörsiktighetsåtgärder vid hantering av CD-skivor Försiktighetsåtgärder vid förvaring av CD-skivorFelsökning Specifikationer106 Austria BelgiumCanada China107