Denon DRA-F100, DCD-F100 manual Safety Instructions, Handle the power supply cord carefully

Page 2

SAFETY INSTRUCTIONS

IMPORTANT TO SAFETY

NOTE:

1.Read Instructions – All the safety and operating instructions should be read before the appliance is operated.

2.Retain Instructions – The safety and operating instructions should be retained for future reference.

3.Heed Warnings – All warnings on the appliance and in the operating instructions should be adhered to.

4.Follow Instructions – All operating and use instructions should be followed.

5.Water and Moisture – The appliance should not be used near water – for example, near a bathtub, washbowl, kitchen sink, laundry tub, in a wet basement, or near a swimming pool, and the like.

6.Carts and Stands – The appliance should be used only with a cart or stand that is recommended by the manufacturer.

6A. An appliance and cart combination should be moved with care.

Quick stops, excessive force, and uneven surfaces may cause the appliance and cart combination to overturn.

7.Wall or Ceiling Mounting – The appliance should be mounted to a wall or ceiling only as recommended by the manufacturer.

8.Ventilation – The appliance should be situated so that its location or position does not interfere with its proper ventilation. For example, the appliance should not be situated on a bed, sofa, rug, or similar surface that may block the ventilation openings; or, placed in a built-in installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings.

9.Heat – The appliance should be situated away from heat sources such as radiators, heat registers, stoves, or other appliances (including amplifiers) that produce heat.

10.Power Sources – The appliance should be connected to a power supply only of the type described in the operating instructions or as marked on the appliance.

11.Grounding or Polarization – Precautions should be taken so that the grounding or polarization means of an appliance is not defeated.

12.Power-Cord Protection – Power-supply cords should be routed so that they are not likely to be walked on or pinched by items placed upon or against them, paying particular attention to cords at plugs, convenience receptacles, and the point where they exit from the appliance.

14.Cleaning – The appliance should be cleaned only as recommended by the manufacturer.

15.Power Lines – An outdoor antenna should be located away from power lines.

16.Outdoor Antenna Grounding – If an outside antenna is connected to the receiver, be sure the antenna system is grounded so as to provide some protection against voltage surges and built-up static charges. Article 810 of the National Electrical Code, ANSI/NFPA 70, provides information with regard to proper grounding of the mast and supporting structure, grounding of the lead-in wire to an antenna-discharge unit, size of grounding conductors, location of antenna-discharge unit, connection to grounding electrodes, and requirements for the grounding electrode. See Figure A.

17.Nonuse Periods – The power cord of the appliance should be unplugged from the outlet when left unused for a long period of time.

18.Object and Liquid Entry – Care should be taken so that objects do not fall and liquids are not spilled into the enclosure through openings.

19.Damage Requiring Service – The appliance should be serviced by qualified service personnel when:

A.The power-supply cord or the plug has been damaged; or

B.Objects have fallen, or liquid has been spilled into the appliance; or

C.The appliance has been exposed to rain; or

D.The appliance does not appear to operate normally or exhibits a marked change in performance; or

E.The appliance has been dropped, or the enclosure damaged.

20.Servicing – The user should not attempt to service the appliance beyond that described in the operating instructions. All other servicing should be referred to qualified service personnel.

WARNING:

TO PREVENT FIRE OR SHOCK HAZARD, DO NOT EXPOSE THIS APPLIANCE TO RAIN OR MOIS- TURE.

CAUTION:

1.Handle the power supply cord carefully

Do not damage or deform the power supply cord. If it is damaged or deformed, it may cause electric shock or malfunction when used. When removing from wall outlet, be sure to remove by holding the plug attachment and not by pulling the cord.

2.Do not open the top cover

In order to prevent electric shock, do not open the top cover.

If problems occur, contact your DENON DEALER.

3.Do not place anything inside

Do not place metal objects or spill liquid inside the system.

Electric shock or malfunction may result.

CAUTION

RISK OF ELECTRIC SHOCK

DO NOT OPEN

CAUTION:

TO REDUCE THE RISK OF ELECTRIC SHOCK, DO NOT REMOVE COVER (OR BACK). NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALI- FIED SERVICE PERSONNEL.

The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated “dangerous voltage” within the product’s enclosure that may be of sufficient

This system uses the semiconductor laser. To allow you to enjoy music at a stable operation, it is recommended to use this in a room of 5 °C (41 °F) ~ 35 °C (95 °F).

CAUTION:

USE OF CONTROLS OR ADJUSTMENTS OR REFOR-MANCE OF PROCEDURES OTHER THAN THOSE SPECIFIED HEREIN MAY RESULT IN HAZARDOUS RADIATION EXPOSURE.

THE COMPACT DISC PLAYER SHOULD NOT BE ADJUSTED OR REPAIRED BY ANYONE EXCEPT PROPERLY QUALIFIED SERVICE PERSONNEL.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.

This Class B digital apparatus meets all requirements of the Canadian Interference- Causing Equipment Regulations.

Cet appareil numérique de la classe B respecte toutes les exigences du Règlement sur le matériel brouilleur du Canada.

CAUTION

TO PREVENT ELECTRIC SHOCK DO NOT USE THIS (POLARIZED) PLUG WITH AN EXTENSION CORD, RECEPTACLE OR OTHER OUTLET UNLESS THE BLADES CAN BE FULLY INSERTED TO PREVENT BLADE EXPOSURE.

ATTENTION

FIGURE A

EXAMPLE OF ANTENNA GROUNDING

AS PER NATIONAL

ELECTRICAL CODEANTENNA

LEAD IN

WIRE

GROUND

CLAMP

ANTENNA DISCHARGE UNIT (NEC SECTION 810-20)

ELECTRIC

SERVICE

EQUIPMENT

GROUNDING CONDUCTORS (NEC SECTION 810-21)

GROUND CLAMPS

POWER SERVICE GROUNDING

ELECTRODE SYSTEM (NEC ART 250, PART H)

NEC - NATIONAL ELECTRICAL CODE

magnitude to constitute a risk of electric shock to persons.

The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance.

POUR PREVENIR LES CHOCS ELECTRIQUES NE PAS UTILISER CETTE FICHE POLARISEE AVEC UN PROLONGATEUR UNE PRISE DE COURANT OU UNE AUTRE SORTIE DE COURANT, SAUF SI LES LAMES PEUVENT ETRE INSEREES A FOND SANS EN LAISSER AUCUNE PARTIE A DECOUVERT.

2

Image 2
Contents Pagina 020021 036 ~ PaginaDo not open the top cover Safety InstructionsHandle the power supply cord carefully Do not place anything inside0!1!2 Tion lorsque l’appareil n’est pas Thinner come in contact withTime Utilisé pendant de longuesBefore Using Connecting the Included AntennasMain Features AC Outlets Precautions for InstallationConnections System operationsPart NAMES, Functions and Displays Disc tray Power operation switch ON/STANDBYOPEN/CLOSE button Play buttonRemote Control Unit Using the Remote Control UnitRemote Control Unit Part Names and Functions TimeListening to Preset Stations Auto Preset Memory FunctionTuning Presetting AM and FM StationsUsing the Timer Setting the Timer Cancelling the Sleep Timer Various Timer OperationsSetting the Sleep Timer Order of priority of the sleep and everyday timersCompact About Compact DiscsNormal Playback MarkResuming playback Various Playback FunctionsInterrupting playback temporarily Stopping playbackRemote control unit or the 7/9 and 8/6 Example Using a CD containing 15 tracksSingle-track repeat mode is set and Repeat Remote control unit to playPress the automatic/manual search forward button By pressing the Random button when tracks areRepeat mode is set to the all-track repeat mode Track currently being monitored and the elapsedOther Information SpecificationsCleaning Discs Troubleshooting Protector circuitAvant D’UTILISER Votre Appareil Connexion DES Antennes FourniesCaracteristiques Principales Connexions Precaution Precautions’INSTALLATION NOMENCLATURE, Fonctions ET Affichages Touche d’ouverture/fermeture Interrupteur de courant ON/STANDBYOPEN/CLOSE Touche d’arrêtPrécautions d’emploi TlecommandeUtilisation de la télécommande Nomenclature et fonctions de la télécommande Syntonisation Ecoute DE Programmes DE RadioFonction de mémoire préréglée automatique Préréglage de stations AM et FMUtilisation DE LA Minuterie Touche de mémoire Memory Touches de syntonisation haut et bas Tuning UP et DownRéglage de la minuterie Annulation de la minuterie de sommeil Divers fonctionnements de la minuterieRéglage de la minuterie de sommeil Ordre de priorité des minuteries de sommeil et quotidienneLecture normale Lecture DE CDPropos des disques compacts Lecteur CD DCD-F100Reprise de la lecture Diverses fonctions de lectureInterruption momentanée de la lecture Arrêt de la lectureÈme Pression PressionÈre ÈmeTouche aléatoire Touche de recherche en avant Automatique/manuelle 7/9Touche de recherche en arrière Automatique/manuelle 8/6 RandomAutres Informations Nettoyage des disquesDepistage DES Pannes Circuit de protectionAntes DE SU Utilizacion Conexion DE LAS Antenas IncluidasPrincipales Prestaciones LA Instalacion ConexionesPrecaucion Precauciones Para NotaNOMBRES, Funciones Y Visualizaciones DE Piezas Stop Botón de parada OPEN/CLOSE Botón de abrir/cerrarPlay Botón de reproducción Botón búsqueda hacia adelantePrecauciones para su uso Mando a DistanciaUtilización del mando a distancia Nombres de las piezas del mando a distancia y funciones Sintonizacion Escuchando Programas DE RadioFunción Presintonización Automática en la Memoria Presintonización de emisoras AM y FMUtilizacion DEL Programador Botón de Programador TimerBotones de sintonización arriba y abajo Reproductor de CD DCD-F100 Ajustes del programador dormir Sleep TimerVarias operaciones del programador Reproducción normal Reproducción DE CDAcerca de los compact discs Manejo del platillo del discoVolver a iniciar la reproducción Diferentes funciones de reproducciónInterrupción temporal de la reproducción Parar la reproducciónQue Indicaciones Repeat ySerán exhibidas VezBotón búsqueda hacia atrás Automática/manual 8 Botón búsqueda hacia adelante Automática/manual 7/9Botón búsqueda hacia atrás Automática/manual 8/6 Botón al azarLimpieza de los discos Otra InformacionEspecificaciones Localizacion DE Fallos Circuito protectorCanada AustriaBelgium China CzechoSingapore PolandPortugal South Africa