GE ZVC30, ZVC42 Installation Preparation, Tools and Materials Required, Remove the Packaging

Installation Preparation

TOOLS AND MATERIALS REQUIRED		1/4″ pivoting
(NOT SUPPLIED)			1″ conduit (for remote
		hex socket
	Needle-nose pliers			mounting only)
Aluminized				3/8″ socket/	Electric drill and
duct tape	Silicone				appropriate bits
Pencil and tape measure				nut driver
	Safety glasses	Wire nuts
Spirit level				Tin snips		8″ ducting and
						caps as needed
	Gloves
Knife	Step ladder
		Phillips and flat-blade
Plumb line	Flashlight					Strain relief
		screwdrivers		Wire cutter/stripper

REMOVE THE PACKAGING

CAUTION: Wear gloves to protect against sharp edges.

CAUTION: LIFT THE INSERT SLEEVE OUT OF THE BOX BY GRASPING THE SIDES.

1.Open hood carton.

2.Remove the liner, foam and cardboard.

3.Remove the tape securing the filters to the insert sleeve, lift the tabs and remove the filters.

4.Unscrew the 5 nuts securing the damper vent plate assembly, and remove it from the insert sleeve. Set the 5 nuts and the damper vent plate assembly aside, as you will be re-installing it later in the installation process.

5.Remove the screws attaching the insert sleeve to the mounting board. Discard the screws.

6.Grasp the insert sleeve by the outside edges, and lift straight up and out of the carton.

NOTE: Do not lift the insert sleeve by the blower motor.

7.Remove and properly discard the plastic wrapping.

8.Remove the parts box and other packaging.

11