Installation Instructions
STEP 5 INSTALL BLOWER MOTOR
1.Pick up blower motor and rotate so tabs align with damper plate bracket .
2.Insert blower motor into insert sleeve through cutout opening of custom cabinet frame.
3.Place blower motor on damper plate assembly by sliding blower motor tabs into slots of damper plate assembly.
4.While holding blower motor in place, lift right side so that blower motor bolt holes align with bolts protruding from damper plate assembly and secure with lock washers and wing nuts (hand tighten).
STEP 6 CONNECT WIRING HARNESS
NOTE: Connect three routing clips annd two wiring harnesses on double blower models.
Wiring | Brackets |
harness |
|
1.Locate both ends of wiring harness.
2.Connect wiring harness by inserting male into female opening.
3.Carefully route wiring harness and ground wire through two clips attached to blower plate assembly.
21