GE ZVC36, ZVC42, ZVC48, ZVC30 installation instructions 34-1/2 ″, Insert Sleeve

	Design Information
PRODUCT DIMENSIONS
ZVC36	Dimensions and Specifications (in inches)
	Outside Dimensions
	27-1/2″

*Opening

The custom canopy must be sized to fit the insert sleeve. Construct the canopy with an opening that is:

26″W x 13-3/16″D

The opening must be constructed of 3/4″ thick material to allow the sleeve locking clips to engage.

The Supplied Liner

	4-1/4″
	34-1/2″
7-1/2″	1/2″
4″	21-1/4″
	Front side

The stainless steel liner is shipped with each hood insert . This non-combustible liner protects the underside of the canopy.

Custom Liner

If you are not using the supplied liner, you may construct a custom non-combustible liner. Use the supplied liner as a template. The opening must be 26″W x 13-3/16″D.3/4″ thick material must surround the opening to allow the sleeve locking clips to engage. The insert sleeve inside the cabinet should be positioned 1/2″ from the rear wall so that the center of the 8″ duct is 5-1/2″from the rear wall.

14″

The Insert Sleeve

16-3/4″
13″
	14″
Front side	1/2″
7/8″	13″
25-3/4″
	1/2″

The bottom edge of the insert sleeve has a 7/8″ wide flange on the sides and a 1/2″ wide flange on the front and back.

Remote Location for the Control

The control may be removed from the hood and installed into a wall or countertop. A 30-ft . length of wire is supplied to accommodate most installations. A blanking plate covers the opening when the controls are removed.

The overall size of the control is 4-1/4″wide and 2-1/4″deep.

3-11/16″

	Control cutout
1-11/16″

We recommend that the cutout in granite or other hard surfaces be made before the countertop is installed.

6