GE ZVC42, ZVC48, ZVC36, ZVC30 Design Information, Contents, Product Clearances

Design Information

CONTENTS

Design Information		Installation Instructions
Product Clearances	4	Step 1, Install Hood Liner	17
Product Dimensions	5–8
		Step 2, Connect Electrical	18
Advance Planning		Step 3, Install Insert Sleeve	19
Advance Planning	9	Step 4, Install Damper Plate	20
Remote Mounting of the Control (Wired)	9	Step 5, Install Blower Motor	21
Power Supply	9	Step 6, Connect Wiring Harness	21
Duct Fittings	10	Step 7, Install Filters	22
Installation Preparation		Step 8, Finalize Installation	22
Tools and Materials Required	11
Remove the Packaging	11
Parts Provided	12
Ductwork, Wiring Locations	13
Construct Ceiling Support	14
Remote Mounting of the Control – Wired	15, 16

PRODUCT CLEARANCES

The vent hood and liner assembly must be installed 30″ minimum and 36″ maximum above the cooking surface.

•Always refer to the cooktop or range installation instructions for product-specific clearances.

NOTE: Installation height should be measured from the cooking surface to the bottom edge of the metal hood liner or cabinet surface.

NOTE: UL requires any combustible surface to be a minimum of 30″ above the cooking surface.

•This hood must be vented to the outdoors.

•This hood may be mounted onto a wall or installed over an island.

•This hood can be installed over any Monogram electric/gas cooktop or Monogram Professional cooktop or range of equivalent width.

*30″ Minimum required

*36″ Maximum recommended

36″ min.

*NOTE: Rear wall exhaust venting may affect installation height. See page 13.

4