3Com manual Removing the 3C389 PC Card, Turn on the power to the PC

Removing the 3C389 PC Card 2-5

Verify that you are using the correct STP connector. The correct STP connector is labeled with the number 100.

6Turn on the power to the PC.

Proceed to Chapter 3 for instructions on how to install the network drivers.

Removing the 3C389 PC Card

Removing the cable from the 3C389 PC Card makes the operating system behave as if the PC Card has been physically removed from the slot. See Appendix C for more information.

Follow these steps to remove the 3C389 PC Card:

1Switch off the power to the PC.

2With the cable still attached to the 3C389 PC Card, remove the 3C389 PC Card from the PC.

3To detach the cable from the 3C389 PC Card, retract the latching button (the half-circle in the center of the connector) by sliding it backwards away from the 3C389 PC Card.

4Disconnect the cable connector from the 3C389 PC Card.