Remote Software Download 113

Procedure

Recommendation: Prior to performing remote software download, configure your switch. Perform the procedure in Chapter 2, Managing the VCN Access Concentrator, section Configuring the Ethernet Switch for the VCN Access Concentrator.

To use the VCN AP to download software perform the following steps:

Downloading Software to the LCs in the VCN AC

1Remove the cover of the LMA section of the VCN AP to reveal the LMA port, as shown in Figure 86.

Figure 86 LMA Section of the VCN Access Point

Screw hole

E TH E RN E T

Fax-M odem

in e

o w e r

L

P

Local

Management Port

2Connect the management computer to the VCN AP LMA port.

3Using RJ-45 connectors, connect the Ethernet port of the VCN AP to an Ethernet switch 10BaseT port, as shown in Figure 87. Refer to Figure 88 for the network configuration.

Recommendation: Attach the downloading VCN AP to port

26 in the VCN Services Switch 10.

26 in the SuperStack II Switch 1100.

24 in the VCN Services Switch 100.

24 in the SuperStack II Switch 3300.

Page 113
Image 113
3Com DSA-3CV1100-02 service manual Procedure, Downloading Software to the LCs in the VCN AC