102MANAGING THE VCN ACCESS CONCENTRATOR

The gateway that appears is the current gateway. To change the gateway, type the new gateway and press <Enter>.

To avoid changing the gateway, only press <Enter>.

The menu in Figure 79 re-appears. To change the network parameters again, type 1 and press <Enter>.

To save new network parameters:

1Type 0 and press <Enter>.

The question appears:

Do you want to save changes? Y/N [N]

2To

Save changes, type y and press <Enter>.

The messages appear:

The IP parameters were saved in a non-volatile memory.

The changes will take effect after reset

Press ENTER to continue ...

After the user resets Port 1 or the agent, the modified network parameters take effect.

Discard changes, type n and press <Enter> n.

Close Telnet Session

Since Telnet sessions are used in remote network management, it is possible for local and remote central management sessions to be active simultaneously.

To close a Telnet session, type 3 in the Agent Configuration Menu, and press <Enter>.

If a Telnet session does not exist, the message appears:

There isn’t any opened Telnet session

If a Telnet session exists, the message appears:

This will close the currently opened Telnet session

Page 102
Image 102
3Com DSA-3CV1100-02 Save changes, type y and press Enter Messages appear, Discard changes, type n and press Enter n