44 CHAPTER 2: INSTALLING THE VCN ACCESS CONCENTRATOR
Figure22 Removing Wrong Address
To configure additional SuperStack II switches, repeat step2 through
step 4.
5After all switches have been selected, click Set. Clicking Set configures
switches with valid VCN AC and VCN AP IP addresses.
Switches corresponding to invalid IP addresses are not configured with
the VCN AC and VCN AP MAC addresses. Error messages appear in the
ConfApp screen when a Set operation is attempted for invalid IP
addresses. Similarly, attempting to Set a switch which is not connected to
a VCN AC results in the same error messages.
For each wrong switch address the following message appears:
Error Setting the agent.
Click OK to close the message.
At the end of the entire Set operation the following message appears to
inform that the set operation is complete and that switches at invalid
addresses are not configured:
End of Setting.
Agents from red lines were not set!