3Com DSA-3CV1100-02 service manual Default is n, Set Factory Defaults

Central Management 103

To close the Telnet session, type y and press <Enter>.

The message appears:

The action has been done

A message regarding session close does not appear on the Telnet screen.

To cancel session close, type n and press <Enter>.

The message appears:

The action has been canceled

The default is n.

Set Factory Defaults

To restore the user password and network parameters to the factory defaults, type 4 in the Agent Configuration Menu (Figure 78) and press <Enter>.

The messages appear:

This action will return the system parameters to their default values

Do you want to proceed (Y/[N])? :

Confirm or discard the change:

■To confirm,

aType y and press <Enter>.

The messages appear (Figure 80):

Figure 80 Factory Defaults are Set

The factory’s default settings were written to the non-volatile memory

Note: some of the changes will take effect just after reset

Press ENTER to continue ...

bTo use the changes, reset the card (refer to Reset Port for Line Card 1) or the management agent (refer to Reset Agent).