112 MANAGING THE VCN ACCESS CONCENTRATOR
Remote Software Download
This section describes the remote software downloading procedure.
Overview The VCN Access Point is an Ethernet over VDSL modem that combines
the transmission of voice and data in the direction of the VCN Access
Concentrator and separates voice and data in the direction from the VCN
AC towards the user.
A VCN AP can be directly attached to the Ethernet switch for the purpose
of downloading a software release update to other VCN APs and to the
line cards in the VCN ACs. In this application, the VCN AP is connected
directly to the Ethernet network through the Ethernet port and sends and
receives data only. The user is connected to the VCN AP LMA port and
operates a Software Download Menu to perform the software download.
Requirements The following are the requirements for downloading software:
■The downloading VCN AP software is version 3.5 or later.
■The software of the receiving VCN AC LCs is version 3.5 or later.
■The software of the receiving VCN APs is version 3.0 or later.
■The remaining requirements for the VCN APs and VCN AC are the
same as for all operational units.
If the software requirements are not met, then local downloading
procedures must be used. For the VCN AC, refer to the section Loading a
New Software Release Through the LMA in this chapter. For the VCN AP,
refer to the Visitor and Community Network Access Point Service Manual,
Appendix C, Loading Software Through Local Access.