
|
|
| Chapter 5 | |
|
|
| Channelized Data | |
Overview |
|
|
|
|
|
|
|
| |
What Is It? |
|
|
|
|
The Channelized Data option provides an alternative to using Serial Data Boards | ||||
| (SDB) to concentrate data traffic from remote nodes attached to the PathBuilder | |||
| S24x, 26x, and 27x switch through a multiplexer. | |||
| Using one T1 or E1 card installed in a PathBuilder S24x, 26x, and 27x switch, | |||
| Channelized Data supports a greater number of port connections between the | |||
| PathBuilder S24x, 26x, and 27x switch and remote nodes than allowed is by SDBs. | |||
| For example, eight SDB cards installed in the PathBuilder S24x, 26x, and 27x switch | |||
| plus three motherboard ports allow a maximum of 19 connections per node, or two | |||
| ports per SDB card. With Channelized Data you can make up to 30 connections | |||
| using a T1 card or E1 card. | |||
|
|
| Note | |
|
|
| ||
|
|
| ||
|
|
| Each E1 or T1 card contains two ports. However, the Channelized Data option | |
|
|
| only supports up to 30 configured virtual ports for data traffic. The remaining | |
|
|
| virtual ports available on the PathBuilder S24x, 26x, and 27x switch are reserved | |
|
|
| for uncompressed voice traffic. | |
| The Channelized Data option is configurable from the Control Terminal Port. See the | |||
| “Configuring Channelized Data” section on page | |||
| a PathBuilder S200 series switch for channelized data operation. | |||
Statistics and |
|
|
|
|
The Channelized Data option uses the standard X.25 and Frame Relay statistics | ||||
Alarms | available for the PathBuilder S200 series switch products family. Refer to the X.25 | |||
| Configuration Basics Guide for information on statistics. | |||
| For details on alarms and reports, refer to the Alarms and Reports manual. | |||
Software |
|
|
|
|
No Software Authorization Key is required to enable Channelized Data on a |
Authorization Key PathBuilder S24x, 26x, and 27x switch.
Channelized Data |