3Com S26x, S27x, S24x installation manual Installing the Transceiver

		Installing the Transceiver
Installing the Transceiver
Introduction
	The transceiver mounts to the DB-15 AUI connector of the Ethernet LAN card or to
	the DB-15 AUI connector on the back panel. The Thin-Net BNC connector provides
	subsequent interface to the coaxial network.
	The SQE can be turned ON and OFF by setting a switch on the side of the housing.
		Note
		The transceiver is shipped with the SQE set to the OFF position.
Transceiver
	Figure 3-7shows a transceiver.
Illustration

Thin-NET BNC Connector

15-Pin D-Type Connector

SQE Switch

Figure 3-7. Transceiver

PathBuilder S24x, 26x, and 27x Switch Hardware Installation 3-23