
Hardware Components
Slot Restriction | The T1 dual port digital PBX interface card occupies slot 8 in the PathBuilder S24x, | ||
| 26x, and 27x switch chassis. | ||
DIP Switch |
|
|
|
The T1 dual port digital PBX interface card contains a single DIP switch bank (SW1) | |||
Location | used to assign the card’s I/O base address. | ||
DIP Switch |
|
|
|
Set the DIP switches on the T1 dual port digital PBX interface card as shown in | |||
Settings | Figure |
|
|
T1/CSU Daughter |
|
|
|
The T1/CSU Daughtercard provides a 1.544 MHz | |||
Card | American service that conforms to AT&T 62411/62421 standard. The card is FCC | ||
| Part 68 Registered and uses eternal clocking derived from the telephone network. | ||
| One or two T1/CSU Daughter Cards can be installed onto the T1 Dual Port card. The | ||
| top card supports port 49 and the bottom supports port 50. | ||
| For instructions for installing the T1/CSU card, refer to “Installing the T1/CSU | ||
| Daughter Card” section in Chapter 3. | ||
Required Cables |
|
|
|
These cables ship with the T1 dual port digital PBX interface card and are required to | |||
| cable the T1 dual port digital PBX interface card to the DSPM/SM cards in the node. | ||
|
|
|
|
| Cable Description | Function |
|
|
|
|
|
| One | Connects up to 3 DSPM/SM cards to interconnect |
|
| MVIP ribbon cable | digital voice traffic between individual cards in the |
|
|
| same PathBuilder S24x, 26x, and 27x switch node. |
|
|
|
|
|
| One | Connects 4 or more DSPM/SM cards to interconnect |
|
| MVIP ribbon cable | digital voice traffic between individual cards in the |
|
|
| same PathBuilder S24x, 26x, and 27x switch node. |
|
|
|
|
|
| Two |
| |
| DB15 cables |
| |
|
| card to a DB15 connector (Product Code 17269). |
|
|
|
|
|
About the PathBuilder S24x, 26x, and 27x switch |