Advantech ADAM 4000 user manual ADAM-4016 Command Table, $Aas

Command Set

ADAM-4016 Command Table

Command Syntax	Command Name	Command Description	Page No.
%AANNTTCCFF	Configuration	Set the address, input range, baud	5-4
		rate, data format, checksum status
		and/or integration time for the
		specified analog input module
$AA2	Configuration Status	Return the configuration	5-10
		parameters for the specified
		analog input module
$AAF	Read Firmware	Return the firmware version code	5-12
	Version	from the specified analog input
		module
$AAM	Read Module Name	Return the module name from the	5-13
		specified analog input module
#AA	Read Analog Input	Return the input value from the	5-14
		specified analog input module in
		the currently configured data
		format
$AA0	Span Calibration	Calibrate an analog input module	5-19
		to correct for gain errors
$AA1	Offset Calibration	Calibrate an analog input module	5-20
		to correct for offset errors
#**	Synchronized	Orders all analog input modules to	5-21
	Sampling	sample their input values and store
		them in special registers
$AA4	Read Synchronized	Returns the value that was stored	5-22
	Data	in the specified module's register
		after the #** command
$AA6	Get Excitation	Returns either last value sent to	5-65
	Voltage Output Value	specified module by $AA7
		command, or start-up output
		voltage
$AA7	Excitation Voltage	Direct output excitation voltage	5-66
	Output	data to a specified module
$AAS	Start-up Voltage	Stores a default value in a	5-67
	Output Configuration	specified module. The output value
		will take effect upon atartup.
$AAE	Trim Calibration	Trims specified module a number	5-69
		of units up or down
$AAA	Zero Calibration	Tells the module to store	5-70
		paramenters for zero calibration
$AAB	Span Calibration	Tells the module to store	5-71
		parameters for span calibration

(Continued on following page)

4-12 ADAM 4000 Series User’s Manual