Advantech ADAM 4000 user manual ADAM-4024 Command Table

Chapter 4

ADAM-4024 Command Table

Command Syntax	Command Name	Command Description	Page
			No.
%AANNTTCCFF	Configuration	Set the address, output range,	6-19
		baud rate, data format, slew rate
		and/or checksum status
#AACn(data)	Analog Data Out	Directs output data to a specified	6-20
		module
#AASCn(data)	Set Startup Data	Set data As CHn StartUp Data	6-20
#AAECn(data)	Set Emergency	Set data As CHn Emergency	6-20
	Stop	Stop Data
#**	N/A	Synchrous Sample IDI	6-20
$AA0Cn	4 mA Calibration	Tells the module to store	6-20
		parameters for 4 mA Calibration
$AA1Cn	20 mA Calibration	Tells the module to store	6-20
		parameters for 20 mA Calibration
$AA2	Configuration	Read back Module status	6-20
	Status
$AA3Cn(number of	Trim Calibration	Trims specified module a number	6-20
counts)		of units up/down
$AA4	Start-up output	Stores a default output value in a	6-20
	current/voltage	specified module. The output
	configuration	value will take effect upon startup.
$AA5	Reset Status	Read Back Reset Times After Last	6-20
		$AA5 CMD And Clear This ounter
$AA6Cn	Last Value	Returns either last value sent to	6-20
	Readback	specified module by #AA
		command, or start-up output
		current/voltage
$AA7CnRxx	Set Output Type	Set CHn Output Type	6-20
$AA8Cn	Current Readback	Returns measured value of the	6-21
		current/voltage flowing through
		current loop
$AAF	Read Firmware	Return the firmware version code	6-21
	Version	from the specified analog output
		module
$AAM	Read Module	Return the module name from the	6-21
	Name	specified analog output module

(Continued on following page)

Chapter 4 Command Set 4-25