Advantech ADAM 4000 , ADAM-4080D Command Table , (Continued on following page)

Command Set
4-
40 ADAM 4000 Series User’s Manual
ADAM-4080D Command Table
Command Syntax Command Name Command Description Page
No.
%AANNTTCCFF Configuration Sets the address, input mode,
baud rate, checksum status and/or
frequency gate time for a specified
counter/ frequency module
7-28
$AA2 Configuration Status Returns configuration parameters
from the specified
counter/frequenc
y
modul e
7-30
$AAF Read Firmware
Version Return firmware version code from the specified coun ter/fre quency
module
7-31
$AAM Read Module Name Return the module name from the
specified counter/frequency
module
7-32
$AABS Set Input Signal
Mode Sets the input signal mode of the specified counter/frequency
module to either non-isolated or
photo-isolated input si
g
nals
7-33
$AAB Read Input Signal
Mode Read the input signal mode of the specified counter/frequency
module.
7-34
#AAN Read Counter or
Frequency Value Returns the value of counter 0 or counter 1 from a specified counter/
frequenc
y
module in hex format
7-35
$AA8V Select LED Data
Origin Select whether LED will display data from the counter/frequency
module directly or from the host
computer
7-36
$AA8 Read LED Data
Origin Returns the status of the LED Data origin. Origin is either direct from
module or from host computer
7-37
$AA9(data) Send Data to LED The host computer sends data to
the addressed module to display
on its LED. This command is valid
only after selectting to display host
computer data
(
$AA8V
)
7-38
(Continued on following page)