Agilent Technologies 54621D, 24A, 42A, 54621A, 22A, 41A manual Getting Started

Getting Started

When you use the oscilloscopes to help test and troubleshoot your systems, you may do the following:

•Prepare the oscilloscope by connecting it to power and setting up the handle and screen intensity as desired.

•Define the measurement problem by understanding the parameters of the system you wish to test, and the expected system behavior.

•Set up channel inputs by connecting the probes to the appropriate signal and ground nodes in the circuit under test.

•Define the trigger to reference the waveform data at a specific event of interest.

•Use the oscilloscope to acquire data, either in continuous or single- shot fashion.

•Examine the data and make measurements on it using various features.

•Save the measurement or configuration for later re-use or comparison with other measurements.

Repeat the process as necessary until you verify correct operation or find the source of the problem.

MegaZoom Technology Operates with Untriggered Data

With the MegaZoom technology built into the oscilloscope, you can operate the oscilloscope with untriggered data. All you do is press Run or Single while in Auto trigger mode, then examine the data to set up a trigger.

1-2