Agilent Technologies 54621A, 54621D To save traces and setups to a new file on the floppy disk

MegaZoom Concepts and Oscilloscope Operation

To save traces and setups to a new file on the floppy disk

To save traces and setups to a new file on the floppy disk

1 To create a new file name, press the New File softkey.

If you do not want to overwrite an existing file, use this menu to enter a new file name. New file names can be up to eight characters long. New file names can only be written to the floppy disk, not the internal memory.

2Turn the Entry knob to select the first character in the file name.

Turning the Entry knob selects a character to enter into the highlighted position shown in the "New file name =" line above the softkeys and in the Spell softkey.

3Press the Enter softkey to enter the selected character and go to the next character position.

You may position the highlight on any character in the file name by successively pressing the Enter softkey.

4To delete a character from the file name, press the Enter softkey until the letter you want to delete is highlighted, then press the Delete Character softkey.

5When you are done entering characters for the file name, press the Press to Save softkey to save the file.

Two files will be saved to the floppy disk. In the example above, SCOPE1.TRC will be the trace file and SCOPE1.SCP will be the setup file. You do not need to remember these file extensions because you can select trace, setup, or both when you recall this information using the Recall menu.

4-51