AMD Am186TMER, Am188TMER - page 42

System Overview

3-10

Table 3-1 PIO Pin Assignments—Numeric Listing

Notes:

1. These pins are used by emulators. (Emulators also use S2–S0, RES, NMI, CLKOUTA, BHE,

ALE, AD15–AD0, and A16–A0.)

2. These pins revert to normal operation if BHE/ADEN (Am186ER microcontroller) or RFSH2/ADEN(Am188ER microcontroller) is held Low during power-on reset.

3. When used as a PIO, input with pullup option available.

4. When used as a PIO, input with pulldown option available.

PIO No. Associated Pin Power-On Reset Status

0 TM RIN1 Input with pullup

1 TM ROUT1 Input with pulldown

2PCS

6/A2 Input with pullup

3PCS

5/A1 Input with pullup

4DT/R Normal operation(3)

5DEN Normal operation(3)

6SRDY Normal operation(4)

7(1) A17 Normal operation(3)

8(1) A18 Normal operation(3)

9(1) A19 Normal operation(3)

10 TMROUT0 Input with pulldown

11 TMRIN0 Input with pullup

12 DRQ0 Input with pullup

13 DRQ1 Input with pullup

14 MCS0 Input with pullup

15 MCS1 Input with pullup

16 PCS0 Input with pullup

17 PCS1 Input with pullup

18 PCS2 Input with pullup

19 PCS3 Input with pullup

20 SCLK Input with pullup

21 SDATA Input with pullup

22 SDEN0 Input with pulldown

23 SDEN1 Input with pulldown

24 MCS2 Input with pullup

25 MCS3/RFSH Input with pullup

26(1,2) UZI/CLKSEL2 Input with pullup

27 TXD Input with pullup

28 RXD Input with pullup

29(1,2) S6/CLKSEL1 Input with pullup

30 INT4 Input with pullup

31 INT2 Input with pullup

Contents

Main 1997 Advanced Micro Devices, Inc. All rights reserved. Trademarks IF YOU HAVE QUESTIONS, WERE HERE TO HELP YOU. Customer Service Hotline and World Wide Web Support Documentation and Literature Page TABLE OF CONTENTS Page Page Page LIST OF FIGURES Page LIST OF TABLES Page PREFACE INTRODUCTION AND OVERVIEW DESIGN PHILOSOPHY PURPOSE OF THIS MANUAL Am186 and Am188 Family Instruction Set Manual, INTENDED AUDIENCE AMD DOCUMENTATION E86 Microcontroller Family 1 1.1 KEY FEATURES AND BENEFITS 1.2 DISTINCTIVE CHARACTERISTICS Page Features and Performance 1-4 Figure 1-1 Am186ER Microcontroller Block Diagram Features and Performance 1-5 Figure 1-2 Am188ER Microcontroller Block Diagram 1.3 APPLICATION CONSIDERATIONS 1.3.1 Clock Generation 1.3.2 Memory Interface 1.3.3 Serial Communications Port Page 2 2.1 REGISTER SET Programming 2-2 Figure 2-1 Register Set 2.1.1 Processor Status Flags Register undefined Figure 2- 2 Processor Status Flags Register (FLAGS) 2.2 MEMORY ORGANIZATION AND ADDRESS GENERATION 2.3 I/O SPACE 2.4 INSTRUCTION SET The Am186 and Am188 Family Instruction Set Manual Page Page Page 2.5 SEGMENTS 2.6 DATA TYPES Programming 2-9 Figure 2-5 Supported Data Types 2.7 ADDRESSING MODES Register and Immediate Operands Memory Operands 3 3.1 PIN DESCRIPTIONS Page Page Page Page Page Page Page Page Page Page Page Page Page Page Page 3.1.1 Pins That Are Used by Emulators 3.2 BUS OPERATION System Overview 3-19 Figure 3-1 Am186ER Microcontroller Address BusNormal Read and Write Operation Figure 3-2 Am186ER MicrocontrollerRead and Write with Address Bus Disable In Effect System Overview 3-20 Figure 3-3 Am188ER Microcontroller Address BusNormal Read and Write Operation Figure 3-4 Am188ER MicrocontrollerRead and Write with Address Bus Disable In Effect 3.3 BUS INTERFACE UNIT Am186ER and Am188ER Microcontrollers Data Sheet 3.3.1 Nonmultiplexed Address Bus 3.3.2 Byte Write Enables 3.3.3 Pseudo Static RAM (PSRAM) Support Page 3.4 CLOCK AND POWER MANAGEMENT UNIT 3.4.1 Phase-Locked Loop (PLL) 3.4.2 Crystal-Driven Clock Source 3.4.3 External Source Clock 3.4.4 System Clocks 3.4.5 Power-Save Operation Page 4 4.1 OVERVIEW Peripheral Control Block 4-2 Figure 4-1 Peripheral Control Block Register Map Gaps in offset addresses indicate reserved registers. Changed from 80C186 microcontroller. Peripheral Control Block 4-3 Changed from 80C186 microcontroller. Gaps in offset addresses indicate reserved registers. 4.1.1 Peripheral Control Block Relocation Register (RELREG, Offset FEh) 4.1.2 Reset Configuration Register (RESCON, Offset F6h) 4.1.3 Processor Release Level Register (PRL, Of fset F4h) 4.1.4 Power-Save Control Register (PDCON, Offset F0h) 4.2 INITIALIZATION AND PROCESSOR RESET Note: Registers not listed in this table are undefined at reset. Page 5 5.1 OVERVIEW Note: The PCS4 chip select is not implemented on the Am186ER and Am188ER microcontrollers. A write will enable an external memory or peripheral chip select register. 5.2 CHIP SELECT TIMING 5.3 READY AND WAIT-STATE PROGRAMMING 5.4 CHIP SELECT OVERLAP 5.5 CHIP SELECT REGISTERS 5.5.1 Upper Memory Chip Select Register (UMCS, Offset A0h) Page 5.5.2 Low Memory Chip Select Register (LMCS, Offset A2h) Page 5.5.3 Midrange Memory Chip Select Register (MMCS, Offset A6h) Page 5.5.4 PCS and MCS Auxiliary Register (MPCS, Offset A8h) Page 5.5.5 Peripheral Chip Select Register (PACS, Offset A4h) Page Page 6 6.1 OVERVIEW not 6.2 INTERACTION WITH EXTERNAL RAM 6.3 EMULATOR AND DEBUG MODES 6.3.1 Internal Memory Disable 6.3.2 Show Read Enable 6.4 INTERNAL MEMORY CHIP SELECT REGISTER (IMCS, OFFSET ACh) Page 7 7.1 OVERVIEW 7.1.1 Memory Partition Register (MDRAM, Offset E0h) 7.1.2 Clock Prescaler Register (CDRAM, Offset E2h) 7.1.3 Enable RCU Register (EDRAM, Offset E4h) 8 8.1 OVERVIEW 8.1.1 Definitions of Interrupt Terms Overall Priority Page 8.1.2 Interrupt Conditions and Sequence 8.1.3 Interrupt Priority 8.1.4 Software Exceptions, Traps, and NMI Page 8.1.5 Interrupt Acknowledge 8.1.6 Interrupt Controller Reset Conditions 8.2 MASTER MODE OPERATION 8.2.1 Fully Nested Mode 8.2.2 Cascade Mode 8.2.3 Special Fully Nested Mode 8.2.4 Operation in a Polled Environment 8.2.5 End-of-Interrupt Write to the EOI Register 8.3 MASTER MODE INTERRUPT CONTROLLER REGISTERS 8.3.1 INT0 and INT1 Control Registers (I0CON, Offset 38h, I1CON, Offset 3Ah) Page 8.3.2 INT2 and INT3 Control Registers (I2CON, Offset 3Ch, I3CON, Offset 3Eh) 8.3.3 INT4 Control Register (I4CON, Offset 40h) Page 8.3.5 Watchdog Timer Interrupt Control Register (WDCON, Offset 42h) (Master Mode) Must 8.3.6 Serial Port Interrupt Control Register (SPICON, Offset 44h) 8.3.7 Interrupt Status Register (INTSTS, Offset 30h) 8.3.8 Interrupt Request Register (REQST, Offset 2Eh) 8.3.9 In-Service Register (INSERV, Offset 2Ch) 8.3.10 Priority Mask Register (PRIMSK, Offset 2Ah) 8.3.11 Interrupt Mask Register (IMASK, Offset 28h) 8.3.12 Poll Status Register (POLLST, Offset 26h) 8.3.13 Poll Register (POLL, Offset 24h) 8.3.14 End-of-Interrupt Register (EOI, Offset 22h) 8.4 SLAVE MODE OPERATION 8.4.1 Slave Mode Interrupt Nesting 8.4.2 Slave Mode Interrupt Controller Registers Page 8.4.4 Interrupt Status Register (INTSTS, Offset 30h) 8.4.5 Interrupt Request Register (REQST, Offset 2Eh) 8.4.6 In-Service Register (INSERV, Offset 2Ch) 8.4.7 Priority Mask Register (PRIMSK, Offset 2Ah) 8.4.8 Interrupt Mask Register (IMASK, Offset 28h) 8.4.9 Specific End-of-Interrupt Register (EOI, Offset 22h) 8.4.10 Interrupt Vector Register (INTVEC, Offset 20h) Page 9 9.1 OVERVIEW 9.2 PROGRAMMABLE REGISTERS 9.2.1 Timer Operating Frequency 9.2.2 Timer 0 and Timer 1 Mode and Control Registers (T0CON, Offset 56h, T1CON, Offset 5Eh) Page 9.2.3 Timer 2 Mode and Control Register (T2CON, Offset 66h) 9.2.4 Timer Count Registers (T0CNT, Offset 50h, T1CNT, Offset 58h, T2CNT, Offset 60h) Page Page 10 10.1 OVERVIEW 10.2 DMA OPERATION DMA Controller 10-2 Figure 10-1 DMA Unit Block Diagram 10.3 PROGRAMMABLE DMA REGISTERS 10.3.1 DMA Control Registers (D0CON, Offset CAh, D1CON, Offset DAh) Page Page Page Page 10.3.5 DMA Source Address High Register (High Order Bits) (D0SRCH, Offset C2h, D1SRCH, Offset D2h) Page 10.4 DMA REQUESTS 10.4.1 Synchronization Timing 10.4.2 DMA Acknowledge 10.4.3 DMA Priority 10.4.4 DMA Programming 10.4.5 DMA Channels on Reset Page 11 11.1 OVERVIEW 11.2 PROGRAMMABLE REGISTERS 11.2.1 Serial Port Control Register (SPCT, Offset 80h) Page 11.2.2 Serial Port Status Register (SPSTS, Offset 82h) 11.2.3 Serial Port Transmit Data Register (SPTD, Offset 84h) 11.2.4 Serial Port Receive Data Register (SPRD, Offset 86h) 11.2.5 Serial Port Baud Rate Divisor Register (SPBAUD, Offset 88h) phase Page 12 12.1 OVERVIEW 12.1.1 Four-Pin Interface 12.2 PROGRAMMABLE REGISTERS 12.2.1 Synchronous Serial Status Register (SSS, Offset 10h) 12.2.2 Synchronous Serial Control Register (SSC, Offset 12h) Page 12.2.4 Synchronous Serial Receive Register (SSR, Offset 18h) 12.3 SSI PROGRAMMING Synchronous Serial Interface 12-8 Figure 12-5 Synchronous Serial Interface Multiple Write Figure 12-6 Synchronous Serial Interface Multiple Read 13 13.1 OVERVIEW Page 13.2 PIO MODE REGISTERS 13.2.1 PIO Mode 1 Register (PIOMODE1, Offset 76h) 13.2.2 PIO Mode 0 Register (PIOMODE0, Offset 70h) 13.3 PIO DIRECTION REGISTERS Power-On Reset State 13.3.1 PIO Direction 1 Register (PDIR1, Offset 78h) 13.3.2 PIO Direction 0 Register (PDIR0, Offset 72h) 13.4 PIO DATA REGISTERS 13.4.1 PIO Data Register 1 (PDATA1, Offset 7Ah) 13.4.2 PIO Data Register 0 (PDATA0, Offset 74h) 13.5 OPEN-DRAIN OUTPUTS Page APPENDIX A Page Page A-4 Figure A-1 Internal Register Summary Register Summary A-5 A-6 Register Summary A-7 A-8 Register Summary A-9 A-10 Register Summary A-11 A-12 Register Summary A-13 A-14 Register Summary A-15 A-16 INDEX A B Page C D E F G H I K L M N O P Q R S T U W X Z