©2008 Advanced Micro Devices, Inc. GEVENT/GPE/GPM/ExtEvent
AMD SB600 Register Reference Manual Proprietary Page 283
4.2.1 GEVENT as GPIO
GEVENT[1:0] are inputs only. Their status can be read from PM I/O Reg 92h Bit[1:0].
GEVENT[7:2] can be programmed either as GPIO lines or as GPE lines (see section 4.2.2).
PM I/O Reg 91h Bit[7:2] defines GEVENT[7:2] pins as output or input
0: Enable output
1: Tris-tate (input)
For GEVENT pins defined as output, PM I/O Reg 90h Bit[7:2] sets the output value
0: Output low
1: Output high
For GEVENT pins defined as input, PM I/O Reg 92h Bit[7:2] are used to read the input status.
GEVEN8 can be programmed either as GPIO line or as GPE line (see section 4.2.2).
PM I/O Reg 84h Bit[3] defines GEVENT8 pins as output or input
0: Enable output
1: Tris-tate (input)
For GEVENT8 pin defined as output, PM I/O Reg 84h Bit[2] sets the output value
0: Output low
1: Output high
For GEVENT8 pin defined as input, PM I/O Reg 84h Bit[4] is used to read the input status.
4.2.2 General Purpose Event (GPE)
The General Purpose Event (GPE) pins can generate wake events, SCI, SMI#, SMI# followed by SCI, or
IRQ13.
When not used as GPE pins, these pins may also be used as GPIO pins as described in sections 4.1.1,
4.2.1, 4.2.3, 4.2.4.
The GPE pins include:
GEVENT[8:0]
GPM[9:0]
EXTEVENT[1:0]
GPIO0, GPIO2, GPIO64
Table 4-3: GPE Pins
Pin Name
(*Note 1) Multi-Function
Selection Configure Bit
00 – SCI or SMI#
01 – SMI#
10 – SMI#
followed by SCI
11 - IRQ13
Trigger Configure
0–Falling edge
1–Rising edge
Enable
ACPI Event Status
(Write 1 to ACPI
GPE00h Bit to
Clear)
Power
Domain
GEVENT0/
GA20IN
SMBus
Reg64h[Bit11]
0: GEVENT0
1: GA20IN
PM IO
Reg30h[Bit1:0]
PM IO
Reg36h[Bit 0]
ACPI
GPE04h[Bit 0]
PM IO
Reg39h[Bit 0]
or ACPI
GPE00h[Bit0]
S0
GEVENT1/
KBRST#
SMBus
Reg64h[Bit9]
0: KBRST#
1: GEVENT1
PM IO
Reg30h[Bit3:2]
PM IO
Reg36h[Bit 1]
ACPI
GPE04h[Bit 1]
PM IO
Reg39h[Bit 1]
or ACPI
GPE00h[Bit 1]
S0