Programming

Configuration Port Commands (Cont.)

Command

Description

 

 

 

SET DATE

Prompts you to enter the new date for the Master.

 

When the date is set on the Master, the new date will be reflected on all

 

devices in the system that have clocks (i.e. touch panels). By the same

 

token, if you set the date on any system device, the new date will be

 

reflected on the system’s Master, and on all connected devices.

 

This will not update clocks on devices connected to another Master (in

 

Master-to-Master systems).

 

Example:

 

 

>SET DATE

 

 

Enter Date: (mm/dd//yyyy) ->

 

 

SET DNS <D:P:S>

Prompts you to enter a Domain Name, DNS IP #1, DNS IP #2, and DNS

 

IP #3. Then, enter Y (yes) to approve/store the information in the Master.

 

Entering N (no) cancels the operation.

 

Example:

 

 

>SET DNS [0:1:0]

 

 

-- Enter New Values or just hit Enter to keep current settings --

 

Enter Domain Suffix: amx.com

 

Enter DNS Entry 1

: 192.168.20.5

 

Enter DNS Entry 2

: 12.18.110.8

 

Enter DNS Entry 3

: 12.18.110.7

 

You have entered: Domain Name: amx.com

 

 

DNS Entry 1: 192.168.20.5

 

 

DNS Entry 2: 12.18.110.8

 

 

DNS Entry 3: 12.18.110.7

 

Is this correct? Type Y or N and Enter -> Y

 

Settings written. Device must be rebooted to enable new settings

 

 

SET DUET MEMORY

Set the amount of memory allocated for Duet Java pool. This is the cur-

 

rent Java memory heap size as measured in Megabytes. This

 

feature is used so that if a NetLinx program requires a certain size of

 

memory be allotted for its currently used Duet Modules, it can be reserved

 

on the target Master.

 

 

Valid values are 1 - 16 for 32 MB systems and 1 - 48 for a 64 MB

 

system. This setting does not take effect until the next reboot.

 

Note: If you are trying to accomplish this setting of the Duet Memory size

 

via a NetLinx program, the program command

 

"DUET_MEM_SIZE_SET(int)" should call REBOOT() following a set.

 

 

SET ETHERNET MODE <CMD>

This command sets the current ethernet configuration settings -

 

auto OR speed = 10 100, duplex = full half

 

Example:

 

 

set ethernet mode auto

 

set ethernet mode speed=100 duplex=full

 

Note: See GET ETHERNET MODE.

 

 

SET FTP PORT

Enables/Disables the IP port listened to for FTP connections.

 

Example:

 

 

>SET FTP PORT

 

 

FTP is enabled

 

 

Do you want to enable (e) or disable (d) FTP (enter e or d) :

 

FTP enabled, reboot the master for the change to take affect.

 

 

 

NI-3101-SIG Signature Series NetLinx Integrated Controller

145

 

 

Page 151
Image 151
AMX NI-3101-SIG manual Prompts you to enter the new date for the Master, Master-to-Master systems