AMX NI-3101-SIG manual Ptof, Pton, Meters for the IR Ports, SET IO Link

	Programming
IR/Serial Send_Commands (Cont.)
Command	Description
PTOF	This time increment is stored in permanent memory. This command also sets
Set the time duration	the delay between pulses generated by the 'PON' or 'POF' send commands in
	tenths of seconds. It also sets the delay required after a power ON command
between power pulses in
	before a new IR function can be generated. This gives the device time to power
.10-second increments.
	up and get ready for future IR commands.
	Syntax:
	SEND_COMMAND <DEV>,"'PTOF',<time>"
	Variable:
	time = 0 - 255. Given in 1/10ths of a second. Default is 15 (1.5 seconds).
	Example:
	SEND_COMMAND IR_1,"'PTOF',15"
	Sets the time between power pulses to 1.5 seconds for the IR_1 device.
PTON	This time increment is stored in permanent memory. This command also sets
Set the time duration of the	the pulse length for each pulse generated by the 'PON' or 'POF' send
	commands in tenths of seconds.
power pulses in
.10-second increments	Syntax:
	SEND_COMMAND <DEV>,"'PTON',<time>"
	Variable:
	time = 0 - 255. Given in 1/10ths of a second. Default is 5 (0.5 seconds).
	Example:
	SEND_COMMAND IR_1,"'PTON',15"
	Sets the duration of the power pulse to 1.5 seconds for the IR_1 device.
SET BAUD	Only valid if the port is in Data Mode (see SET MODE command).
Set the IR port's DATA mode	Syntax:
communication parameters.	SEND_COMMAND <DEV>,"'SET BAUD
	<baud>,<parity>,<data>,<stop>'"
	Variables:
	baud = baud rates are: 19200, 9600, 4800, 2400, and 1200.
	parity = N (none), O (odd), E (even), M (mark), S (space).
	data = 7 or 8 data bits.
	stop = 1 and 2 stop bits.
	Note: AMX does not recommend using a cable longer than 10 feet
	(3.05 meters) for the IR Ports.
	Example:
	SEND_COMMAND IR_1,"'SET BAUD 9600,N,8,1'"
	Sets the IR_1 port's communication parameters to 9600 baud, no parity, 8 data
	bits, and 1 stop bit.
SET IO LINK	The I/O status is automatically reported on channel 255 on the IR port. The I/O
Link an IR or Serial port to a	channel is used for power sensing (via a PCS or VSS). A channel of zero
	disables the I/O link.
selected I/O channel for use
	Syntax:
with the 'DE', 'POD', 'PON',
and 'POF' commands.	SEND_COMMAND <DEV>,"'SET IO LINK <I/O number>'"
	Variable:
	I/O number = 1 - 8. Setting the I/O channel to 0 disables the I/O link.
	Example:
	SEND_COMMAND IR_1,"'SET IO LINK 1'"
	Sets the IR_1 port link to I/O channel 1. The IR port uses the specified I/O input
	as power status for processing 'PON' and 'POF' commands.

NI-3101-SIG Signature Series NetLinx Integrated Controller 163