Programming

Configuration Port Commands (Cont.)

Command

Description

 

 

 

 

SET HTTP PORT

Sets the IP port listened to for HTTP connections.

 

Example:

 

 

 

>SET HTTP PORT

 

 

 

Current HTTP port number = 80

 

Enter new HTTP port number (Usually 80) (0=disable HTTP) :

 

Setting HTTP port number to

 

New HTTP port number set, reboot the master for the change

 

to take effect.

 

 

 

 

SET HTTPS PORT

Sets the IP port listened to for HTTPS connections.

 

Example:

 

 

 

>SET HTTPS PORT

 

 

 

Current HTTPS port number = 443

 

Enter new HTTPS port number (Usually 443) (0=disable HTTPS) :

 

Once you enter a value and press the ENTER key, you get the following

 

message:

 

 

 

Setting HTTPS port number to

 

New HTTPS port number set, reboot the master for the change

 

to take affect.

 

 

 

 

SET ICSP PORT

Sets the IP port listened to for ICSP connections.

 

Example:

 

 

 

>SET ICSP PORT

 

 

 

Current ICSP port number = 1319

 

Enter new ICSP port number (Usually 1319) (0=disable ICSP) :

 

Once you enter a value and press the ENTER key, you get the following

 

message:

 

 

 

Setting ICSP port number to

 

New ICSP port number set, reboot the master for the change

 

to take affect.

 

 

 

 

SET ICSP TCP TIMEOUT

Sets the timeout period for ICSP and i!-WebControl TCP connections.

 

Example:

 

 

 

>SET ICSP TCP TIMEOUT

 

 

This will set the timeout for TCP connections for both ICSP and

 

i!-WebControl.When no communication has been detected for the

 

specified number of seconds, the socket connection is closed.ICSP

 

and i!-WebControl have built-in timeouts and reducing the TCP

 

timeout below these will cause undesirable results. The default

 

value is 45 seconds.

 

 

The current ICSP TCP timeout is 45 seconds

 

Enter new timeout (in seconds):

 

Once you enter a value and press the ENTER key, you get the following

 

message:

 

 

 

New timeout value set (in affect immediately).

 

 

SET IP <D:P:S>

Prompts you to enter a Host Name, Type (DHCP or Fixed), IP Address,

 

Subnet Mask, and Gateway IP Address.

 

Enter Y (yes) to approve/store the information into the Master.

 

Entering N (no) cancels the operation.

 

Example:

 

 

 

>SET IP [0:1:0]

 

 

 

--- Enter New Values or just hit Enter to keep current settings ---

 

Enter Host Name:

MLK_INSTRUCTOR

 

Enter IP type. Type D for DHCP or S for Static IP and then Enter: DHCP

 

Enter Gateway IP:

192.168.21.2

 

You have entered: Host Name

MLK_INSTRUCTOR

 

 

Type

DHCP

 

 

Gateway IP

192.168.21.2

 

Is this correct? Type Y or N and Enter -> y

 

Settings written. Device must be rebooted to enable new settings.

 

 

 

 

146

NI-3101-SIG Signature Series NetLinx Integrated Controller

Page 152
Image 152
AMX NI-3101-SIG manual Subnet Mask, and Gateway IP Address, Enter Y yes to approve/store the information into the Master