Asante Technologies 8000 user manual Installing Port Expansion Modules

Remove the cover plate from the slot where you intend to install the expansion module.

Align the bottom of the expansion module with the rails inside the IntraCore 8000 slot, as shown in Figure 2-2.

Installing Port Expansion Modules

Installing Port Expansion Modules

Up to three optional port expansion modules can be installed in the IntraCore 8000, in addition to a stack matrix module. (A stack matrix module is needed only if more than two units are stacked together. See “Stacking Switches.”)

To install any combination of Gigabit Ethernet Switch (GBIC) modules and 8-port 10/100 Switch modules, use the following procedure.

IImportant: Make sure the IntraCore 8000 is properly installed in an equipment rack or resting on a flat, stable surface. Also make sure the power cord is disconnected for initial installation.

1

2

3 Slide the module into the slot until it stops, then push the module in gently until it seats with the connector.

Figure 2-2 Installing port expansion module

4 Tighten the thumbscrews at the ends of the module’s face plate. Use a straight-bladed screwdriver so the thumb- screws cannot be loosened by hand.

Installation of the module is complete. Repeat this procedure for each module you have purchased.

IImportant: Do not remove modules from the IntraCore 8000 unless you are a qualified System Administrator.

Page 2-7