Asante Technologies 8000 user manual Setting the Intruder Trap, Resetting Security to Defaults

Type t to choose Toggle Port Security Trap.

Security Management

trusted MAC address. If you type 2, you will be prompted to enter the address as follows: xx:xx:xx:xx:xx:xx where the values are hexadecimal, separated by colons.

Setting the Intruder Trap

If you set security level 2 or 3, you should also ensure the Intruder Trap is set. Enabling this trap directs the system to send an alert to the designated trap receiver when an intruder tries to access the port.

1 From the Configuration Menu, type t to access the Secu- rity Management Menu.

2 Type p to access the Port Security Configuration Menu, as shown in Figure 4-5.

3

4 Type 2 to toggle the new node trap (if it is not already enabled).

Inserting/Modifying a Port Trusted MAC Address

When you set port security level 2 or 3 for a port, you specify the port- trusted MAC address. You can change that address for a port without completing all the steps to set the port security.

To add or change the port-trusted MAC address:

1 From the Configuration Menu, type t to access the Secu- rity Management Menu.

2 Type p to access the Port Security Configuration Menu, as shown in Figure 4-5.

3 Type i, then follow the instructions on the screen.

Resetting Security to Defaults

To reset the security measures on the IntraCore 8000 to the factory defaults, access the Security Management Menu by typing t in the Configuration Menu. Then type r to reset all of the security configurations that have been changed back to the factory-set defaults. These defaults and their meanings are discussed in the sections on each security measure, earlier in this chapter.

Page 4-17