4.6.2 CAN2 (Baldor CAN) - X18
Baldor CAN connections are made using the breakout module connector X18.
18
Location | Breakout module, connector X18 | |
|
|
|
Pin | Name | Description |
|
|
|
1 | - | (NC) |
|
|
|
2 | - | (NC) |
|
|
|
3 | - | (NC) |
|
|
|
4 | CAN2 0V | Ground/earth reference for CAN signal |
|
|
|
5 | CAN2 V+ | CAN remote node power V+ |
|
|
|
6 | - | (NC) |
|
|
|
7 | CAN2+ | CAN channel 2 positive |
|
|
|
8 | CAN2- | CAN channel 2 negative |
|
|
|
Description
Baldor proprietary CAN interface using a RJ45 connector.
If NextMove PCI is at the end of the Baldor CAN network a termination resistor must be connected by fitting the termination jumper J7, labelled “BC Term”, on the breakout module.
| MN1903 |
