Baldor MN1903 NextMove PCI can Bracket board, Encoder Splitter/Buffer board, OPT029-501

A.1.9 NextMove PCI CAN Bracket board

This is a compact alternative to using the breakout module when the NextMove PCI controller is being used only as a CAN network manager. Both CAN channels are presented on 9-pin D-type connectors. The board is connected to the NextMove PCI CAN jumpers by a ribbon cable.

The CAN1 (CANopen) channel is presented on a 9-pin male D-type connector and is fitted with the isolated CAN transceiver module.

A supply of 12-24V (60mA) must be connected to CAN1 V+ and CAN1 GND (see section 4.6).

The CAN2 (Baldor CAN) channel is presented on a 9-pin male D-type and is fitted with the non-isolated CAN transceiver module.

Terminators J4 (Baldor CAN) and J5 (CANopen) are provided for terminating the CAN networks. There should be terminators at the both ends of each network and nowhere else.

Catalog	Description
number
OPT030-501	CAN bracket assembly - alternative to breakout module for CAN
	connections only

A.1.10 Encoder Splitter/Buffer board

This is a stand alone PCB that takes an encoder signal, either single ended or differential and gives differential outputs. This is useful for ‘daisy chaining’ an encoder signal from a master across a number of controllers.

Catalog	Description
number
OPT008-501	2-way encoder splitter - allows a single-ended or differential encoder pulse
	train to be shared between two devices
OPT029-501	4-way encoder splitter - allows a single-ended or differential encoder pulse
	train to be shared between four devices

MN1903 Accessories A-7