Black Box MWU2000-G703, MWU2000-X21, MWU2000-V35 manual Appendix B E1 / T1 Applications

2.048Mbps Wireless Modem

Appendix B - E1 / T1 Applications

Introduction

This appendix describes some of the possible ways to connect an E1/T1 Wireless Modem to E1/T1 end equipment. For each possible connection, the indications given by the 2.048Mbps Wireless Modem unit and the expected end equipment behaviour are described. The RJ-45 balanced four-wire interface is also discussed.

The second part of this appendix provides information about E1/T1 LIU board jumper settings. In addition, some explanation is provided on T1 CSU/DSU applications.

E1/T1 Connections and Common Problems - Link Setup

The set-up includes two 2.048Mbps Wireless Modem units, each connected to end equipment. One end equipment unit is the source of the clock and is called “CO” (Central Office). The other unit uses loopback timing (i.e. lock on the CO clock and return it) and is called PBX. The modem connected to the CO is configured as Master, and the other modem as Slave.

Figure B-1. E1/T1 Application.

Table B- 1 summarizes the possible connections and the resulting behaviour

114 SALES: 0118 965 5100