LLDP configuration

8

Changing the minimum time between port reinitializations

The LLDP re-initialization delay timer specifies the minimum number of seconds the device will wait from when LLDP is disabled on a port, until it will honor a request to re-enable LLDP on that port. When you enable LLDP, the system sets the re-initialization delay timer to two seconds. If desired, you can change the default behavior from two seconds to a value between one and ten seconds.

To set the re-initialization delay timer, enter a command such as the following at the Global CONFIG level of the CLI.

Brocade(config)#lldp reinit-delay 5

The above command causes the device to wait five seconds after LLDP is disabled, before attempting to honor a request to re-enable it.

Syntax: [no] lldp reinit-delay <seconds>

The <seconds> variable is a value from 1 – 10. The default is two seconds.

LLDP TLVs advertised by the Brocade device

When LLDP is enabled on a global basis, the Brocade device will automatically advertise the following information, except for the features noted:

General system information:

Management address

Port description

System capabilities

System description (not automatically advertised)

System name

802.1 capabilities:

VLAN name (not automatically advertised)

Untagged VLAN ID

802.3 capabilities:

Link aggregation information

MAC/PHY configuration and status

Maximum frame size

Power-via-MDI information (not automatically advertised) The above TLVs are described in detail in the following sections.

NOTE

The system description, VLAN name, and power-via-MDI information TLVs are not automatically enabled. The following sections show how to enable these advertisements.

General system information for LLDP

Except for the system description, the Brocade device will advertise the following system information when LLDP is enabled on a global basis:

Brocade ICX 6650 Administration Guide

199

53-1002600-01

 

Page 217
Image 217
Brocade Communications Systems 6650 manual Changing the minimum time between port reinitializations