18 Brocade ICX 6650 Administration Guide
53-1002600-01
Basic system parameter configuration
2
•Power supply failure
•Fan failure
•Cold start
•Link up
•Link down
•Bridge new root
•Bridge topology change
•Locked address violation
•BGP4
•OSPF
•VRRP
•VRRP-E
To stop link down occurrences from being reported, enter the following.
Brocade(config)# no snmp-server enable traps link-down
Syntax: [no] snmp-server enable traps <trap-type>
Displaying virtual routing interface statistics
You can enable SNMP to extract and display virtual routing interface statistics from the ifXTable
(64-bit counters).
The following describes the limitations of this feature:
•The Brocade device counts traffic from all virtual interfaces (VEs). For example, in a
configuration with two VLANs (VLAN 1 and VLAN 20) on port 1, when traffic is sent on VLAN 1,
the counters (VE statistics) increase for both VE 1 and VE 20.
•The counters include all traffic on each virtual interface, even if the virtual interface is
disabled.
•The counters include traffic that is denied by ACLs or MAC address filters.
To enable SNMP to display VE statistics, enter the enable snmp ve-statistics command.
Brocade(config)# enable snmp ve-statistics
Syntax: [no] enable snmp ve-statistics
Use the no form of the command to disable this feature once it is enabled.
Note that the above CLI command enables SNMP to display virtual interface statistics. It does not
enable the CLI to display the statistics.
Disabling Syslog messages and traps for CLI access
Brocade devices send Syslog messages and SNMP traps when a user logs into or out of the User
EXEC or Privileged EXEC level of the CLI. The feature applies to users whose access is
authenticated by an authentication-method list based on a local user account, RADIUS server, or
TACACS/TACACS+ serve r.