Brocade Communications Systems 6650 manual Displaying the boot image version running on the device

		Software versions installed and running on a device		3
UNIT 1: SL 1: ICX6650-64 56-port Management Module
	Serial	#: CEN2525H006	(LID: egpHKHKjFFL)
	License: BASE_SOFT_PACKAGE
	P-ENGINE	0: type EC02, rev 01
==========================================================================
UNIT 1: SL 2: ICX6650-64 4-port 160G Module
==========================================================================
UNIT 1: SL 3: ICX6650-64 8-port 80G Module
==========================================================================
800 MHz Power PC processor 8544E (version 0021/0022) 400 MHz bus
65536 KB flash memory
1024 MB DRAM
STACKID 1 system uptime is 23 hours 12 minutes 8 seconds
==========================================================================
UNIT NAME		HARDWARE INFORMATION
	: ICX6650-64
HW REVISION		: 2 (BETA)
Board ID	: 4(ICX6650)

CPLD INFORMATION

CPLD code is RD revision

CPLD CODE REVISION = 6

==========================================================================

The system : started=warm start reloaded=by "reload"

*** NOT FOR PRODUCTION ***

The version information is shown in bold type in this example:

•“07.5.00T321” indicates the flash code version number. The “T321” is used by Brocade for record keeping.

•“labeled as ICXLS07500” indicates the flash code image label. The label indicates the image type and version and is especially useful if you change the image file name.

•“Secondary ICXLS07500.bin” indicates the flash code image file name that was loaded.

Displaying the boot image version running on the device

To determine the boot image running on a device, enter the show flash command at any level of the CLI. The following shows an example output.

Brocade#show	flash
Stack unit 1:	Pri Code size = 12849087,	Version:07.5.00áT323 (ICXLR07500B1.bin)
Compressed
Compressed	Sec Code size = 12848889,	Version:07.5.00T323 (ICXLR07500b1.bin)
Compressed	Boot-Monitor Image size =	524288, Version:07.5.00T7f5
Code Flash	Free Space = 21843968

The boot code version is shown in bold type.

Displaying the image versions installed in flash memory

Enter the show flash command to display the boot and flash images installed on the device. An example of the command output is shown in “Displaying the boot image version running on the device” on page 51:

•The “Compressed Pri Code size” line lists the flash code version installed in the primary flash area.

Brocade ICX 6650 Administration Guide	51
53-1002600-01