Brocade Communications Systems 6650 manual Displaying Snmp groups, Displaying user information

6 Displaying SNMP Information

Displaying SNMP groups

To display the definition of an SNMP group, enter a command such as the following.

Brocade#show snmp group groupname = exceptifgrp security model = v3 security level = authNoPriv ACL id = 2

readview = exceptif writeview = <none>

Syntax: show snmp group

The value for security level can be one of the following.

Security level	Authentication
<none>	If the security model shows v1 or v2, then security level is blank. User names are not
	used to authenticate users; community strings are used instead.
noauthNoPriv	Displays if the security model shows v3 and user authentication is by user name only.
authNoPriv	Displays if the security model shows v3 and user authentication is by user name and the
	MD5 or SHA algorithm.

Displaying user information

To display the definition of an SNMP user account, enter a command such as the following.

Brocade#show snmp user username = bob

ACL id = 2 group = admin security model = v3 group ACL id = 0 authtype = md5

authkey = 3aca18d90b8d172760e2dd2e8f59b7fe

privtype = des, privkey = 1088359afb3701730173a6332d406eec engine ID= 800007c70300e052ab0000

Syntax: show snmp user

Interpreting varbinds in report packets

If an SNMP version 3 request packet is to be rejected by an SNMP agent, the agent sends a report packet that contains one or more varbinds. The varbinds contain additional information, showing the cause of failures. An SNMP manager application decodes the description from the varbind. The following table presents a list of varbinds supported by the SNMP agent.

168	Brocade ICX 6650 Administration Guide
	53-1002600-01