Brocade Communications Systems 6650 manual Vlan-id

		Syslog messages	A
TABLE 57	Brocade Syslog messages (Continued)
Message level	Message	Explanation
Informational	DOT1X : port <portnum> - mac <mac	The RADIUS server returned a MAC address
	address> This device doesn't support ACL	filter while an IP ACL was applied to the
	with MAC Filtering on the same port	port, or returned an IP ACL while a MAC
		address filter was applied to the port.

Informational	DOT1X Port <portnum> is unauthorized
	because system resource is not enough or
	the invalid information to set the dynamic
	assigned IP ACLs or MAC address filters

802.1X authentication could not take place on the port. This happened because strict security mode was enabled and one of the following occurred:

•Insufficient system resources were available on the device to apply an IP ACL or MAC address filter to the port

•Invalid information was received from the RADIUS server (for example, the Filter-ID attribute did not refer to an existing IP ACL or MAC address filter)

Informational	DOT1X: Port <portnum> currently used
	vlan-id changes to <vlan-id>due to
	dot1x-RADIUS vlan assignment

A user has completed 802.1X authentication. The profile received from the RADIUS server specifies a VLAN ID for the user. The port to which the user is connected has been moved to the VLAN indicated by <vlan-id>.

Informational	DOT1X: Port <portnum> currently used	The user connected to <portnum> has
	vlan-id is set back to port default vlan-id	disconnected, causing the port to be moved
	<vlan-id>	back into its default VLAN, <vlan-id>.
Informational	DOT1X: Port <portnum>,	The status of the interface controlled port
	AuthControlledPortStatus change:	has changed from unauthorized to
	authorized	authorized.
Informational	DOT1X: Port <portnum>,	The status of the interface controlled port
	AuthControlledPortStatus change:	has changed from authorized to
	unauthorized	unauthorized.
Informational	Enable super port-config read-only	A user created, re-configured, or deleted an
	password deleted added modified from	Enable or Line password through the Web,
	console telnet ssh web snmp	SNMP, console, SSH, or Telnet session.
	OR
	Line password deleted added modified
	from console telnet ssh web snmp
Informational	ERR_DISABLE: Interface ethernet	Errdisable recovery timer expired and the
	<port-number>, err-disable recovery timeout	port has been reenabled.
Informational	ERR_DISABLE: Interface ethernet 16,	If the wait time (port is down and is waiting
	err-disable recovery timeout	to come up) expires and the port is brought
		up the following message is displayed.

Informational	ERR_DISABLE: Link flaps on port ethernet 16
	exceeded threshold; port in err-disable state

The threshold for the number of times that a port link toggles from “up” to “down” and “down” to “up” has been exceeded.

Informational	Interface <portnum>, line protocol down	The line protocol on a port has gone down.
		The <portnum> is the port number.
Informational	Interface <portnum>, line protocol up	The line protocol on a port has come up.
		The <portnum> is the port number.

Brocade ICX 6650 Administration Guide	279
53-1002600-01