Brocade Communications Systems 6650 manual IPv6 ncopy command

3 Loading and saving configuration files with IPv6

NOTE

To activate this configuration, you must reload (reset) the device.

Syntax: copy tftp running-config startup-config <ipv6-address><source-file-name>[overwrite]

Specify the running-configkeyword to copy the running configuration from the specified IPv6 TFTP server.

The <ipv6-address>parameter specifies the address of the TFTP server. You must specify this address in hexadecimal using 16-bit values between colons as documented in RFC 2373.

The <source-file-name>parameter specifies the name of the file that is copied from the IPv6 TFTP server.

The overwrite keyword specifies that the device should overwrite the current configuration file with the copied file. If you do not specify this parameter, the device copies the file into the current running or startup configuration but does not overwrite the current configuration.

IPv6 ncopy command

The ncopy command for IPv6 allows you to do the following:

•Copy a primary or secondary boot image from flash memory to an IPv6 TFTP server.

•Copy the running configuration to an IPv6 TFTP server.

•Copy the startup configuration to an IPv6 TFTP server

•Upload various files from an IPv6 TFTP server.

Copying a primary or secondary boot Image from flash memory to an IPv6 TFTP server

For example, to copy the primary or secondary boot image from the device flash memory to an IPv6 TFTP server, enter a command such as the following.

Brocade#ncopy flash primary tftp 2001:DB8:e0ff:7837::3 primary.img

This command copies the primary boot image named primary.img from flash memory to a TFTP server with the IPv6 address of 2001:DB8:e0ff:7837::3.

Syntax: ncopy flash primary secondary tftp <ipv6-address><source-file-name>

The primary keyword specifies the primary boot image, while the secondary keyword specifies the secondary boot image.

The tftp <ipv6-address>parameter specifies the address of the TFTP server. You must specify this address in hexadecimal using 16-bit values between colons as documented in RFC 2373.

The <source-file-name>parameter specifies the name of the file you want to copy from flash memory.

Copying the running or startup configuration to an IPv6 TFTP server

For example, to copy a device running or startup configuration to an IPv6 TFTP server, enter a command such as the following.

Brocade#ncopy running-config tftp 2001:DB8:e0ff:7837::3 bakrun.cfg

64	Brocade ICX 6650 Administration Guide
	53-1002600-01