Brocade Communications Systems 6650 State vrrp-state, Mac-address, Mac-addr interface portnum

			Syslog messages	A
TABLE 57	Brocade Syslog messages (Continued)
Message level	Message	Explanation
Notification	VRRP intf state changed,	A state change has occurred in a Virtual
	intf <portnum>, vrid <virtual-router-id>,	Router Redundancy Protocol (VRRP) or
	state <vrrp-state>	VRRP-E IPv4 or IPv6 interface.
		The <portnum> is the port or interface
	VRRP (IPv6) intf state changed,	where VRRP or VRRP-E is configured.
	intf <portnum>, vrid <virtual-router-id>,	The <virtual-router-id> is the virtual router
	state <vrrp-state>	ID (VRID) configured on the interface.
		The <vrrp-state>can be one of the
		following:
		•	init
		•	master
		•	backup
		•	unknown
Warning	DOT1X security violation at port <portnum>,	A security violation was encountered at the
	malicious mac address detected:	specified port number.
	<mac-address>
Warning	Dup IP <ip-addr>detected, sent from MAC	Indicates that the Product Name device
	<mac-addr> interface <portnum>	received a packet from another device on
		the network with an IP address that is also
		configured on the Brocade device.
		The <ip-addr>is the duplicate IP address.

The <mac-addr>is the MAC address of the device with the duplicate IP address.

The <portnum> is the Brocade port that received the packet with the duplicate IP address. The address is the packet source IP address.

Warning	IGMP/MLD no hardware vidx, broadcast to
	the entire vlan. rated limited number

IGMP or MLD snooping has run out of hardware application VLANs. There are 4096 application VLANs per device. Traffic streams for snooping entries without an application VLAN are switched to the entire VLAN and to the CPU to be dropped. This message is rate-limited to appear a maximum of once every 10 minutes. The rate-limited number shows the number on non-printed warnings.

Warning	IGMP/MLD: <vlanId>(<portId>) is V1 but	Port has received a query with a MLD
	rcvd V2 from nbr <ipAddr>	version that does not match the port MLD
		version. This message is rated-limited to
		appear a maximum of once every 10 hours.
Warning	Latched low RX Power TX Power TX Bias	The optical transceiver on the given port
	Current Supply Voltage Temperature	has risen above or fallen below the alarm or
	warning	warning threshold.
	alarm warning, port <port-number>

Brocade ICX 6650 Administration Guide	295
53-1002600-01