Brocade Communications Systems 6650 manual Basic System Parameters, Basic Port Parameters

	Chapter
Basic Software Features	2

In this chapter

•Basic system parameter configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 14

•Specifying an SNTP server . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 20

•Configuring the device as an SNTP server. . . . . . . . . . . . . . . . . . . . . . . . . . . 23

•Basic port parameter configuration . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 31

Table 4 lists the Brocade ICX 6650 switch and the basic software features the switch supports. These features are supported in full Layer 3 software images, except where explicitly noted.

TABLE 4 Supported basic software features

Feature	Brocade ICX
	6650
Basic System Parameters
System name, contact, and location	Yes
SNMP trap receiver and trap source	Yes
address
Virtual routing interface statistics via	Yes
SNMP
Disable Syslog messages and traps for CLI	Yes
access
Cancelling an outbound Telnet session	Yes
System time using a Simple Network Time	Yes
Protocol (SNTP) server or local system
counter
Enabling broadcast mode for SNTP client	Yes
System clock	Yes
Packet-basedbroadcast, multicast, and	Yes
unknown-unicast limits
CLI banners	Yes
Local MAC address for Layer 2	Yes
management traffic
Basic Port Parameters
Port name	Yes
10/100/1000 port speed	Yes
Auto-negotiation	Yes
Auto-negotiation maximum port speed	Yes
advertisement and down-shift

Brocade ICX 6650 Administration Guide	13
53-1002600-01