Brocade Communications Systems 6650 manual Mac-address MgmtPriChg, Mac-address MsgAgeExpiry

		Syslog messages	A
TABLE 57	Brocade Syslog messages (Continued)
Message level	Message	Explanation
Informational	Warm start	The system software (flash code) has been
		reloaded.
Informational	vlan <vlan-id>Bridge is RootBridge	802.1W changed the current bridge to be
	<mac-address> (MgmtPriChg)	the root bridge of the given topology due to
		administrative change in bridge priority.

Informational	vlan <vlan-id>Bridge is RootBridge
	<mac-address> (MsgAgeExpiry)

The message age expired on the Root port so 802.1W changed the current bridge to be the root bridge of the topology.

Informational	vlan <vlan-id>interface <portnum> Bridge
	TC Event (DOT1wTransition)

802.1W recognized a topology change event in the bridge. The topology change event is the forwarding action that started on a non-edge Designated port or Root port.

Informational	vlan <vlan-id> interface <portnum> STP
	state -> <state> (DOT1wTransition)

802.1W changed the state of a port to a new state: forwarding, learning, blocking. If the port changes to blocking, the bridge port is in discarding state.

Informational	vlan <vlan-id>New RootBridge	802.1W selected a new root bridge as a
	<mac-address> RootPort <portnum>	result of the BPDUs received on a bridge
	(BpduRcvd)	port.
Informational	vlan <vlan-id> New RootPort <portnum>	802.1W changed the port role to Root port,
	(RootSelection)	using the root selection computation.
Notification	ACL exceed max DMA L4 cam resource,	The port does not have enough Layer 4 CAM
	using flow based ACL instead	entries for the ACL.
		To correct this condition, allocate more
		Layer 4 CAM entries. To allocate more Layer
		4 CAM entries, enter the following
		command at the CLI configuration level for
		the interface:
		ip access-group max-l4-cam <num>
Notification	ACL insufficient L4 cam resource, using flow	The port does not have a large enough CAM
	based ACL instead	partition for the ACLs
Notification	ACL insufficient L4 session resource, using	The device does not have enough Layer 4
	flow based ACL instead	session entries.
		To correct this condition, allocate more
		memory for sessions. To allocate more
		memory, enter the following command at
		the global CONFIG level of the CLI interface:
		system-max session-limit <num>

Notification	ACL port fragment packet inspect rate
	<rate> exceeded on port <portnum>

The fragment rate allowed on an individual interface has been exceeded.

The <rate> indicates the maximum rate allowed.

The <portnum> indicates the port. This message can occur if fragment thottling is enabled.

Brocade ICX 6650 Administration Guide	283
53-1002600-01