Brocade Communications Systems 6650 Message level Explanation, Level shutdown-degrees C degrees

A Syslog messages

TABLE 57 Brocade Syslog messages (Continued)

Message level Message Explanation

Alert	Temperature <degrees> C degrees, warning
	level <warn-degrees>C degrees, shutdown
	level <shutdown-degrees> C degrees

Indicates an over temperature condition on the active module.

The <degrees> value indicates the temperature of the module.

The <warn-degrees>value is the warning threshold temperature configured for the module.

The <shutdown-degrees> value is the shutdown temperature configured for the module.

Critical	Authentication shut down <portnum> due to
	DOS attack

Denial of Service (DoS) attack protection was enabled for multi-device port authentication on the specified <portnum>, and the per-second rate of RADIUS authentication attempts for the port exceeded the configured limit. The Brocade device considers this to be a DoS attack and disables the port.

Debug	BGP4: Not enough memory available to run
	BGP4

The device could not start the BGP4 routing protocol because there is not enough memory available.

Debug	DOT1X: Not enough memory	There is not enough system memory for
		802.1X authentication to take place.
		Contact Brocade Technical Support.

Error	No of prefixes received from BGP peer
	<ip-addr>exceeds maximum
	prefix-limit...shutdown

The Layer 3 Switch has received more than the specified maximum number of prefixes from the neighbor, and the Layer 3 Switch is therefore shutting down its BGP4 session with the neighbor.

Informational	IPv6: IPv6 protocol disabled on the device	IPv6 protocol was disabled on the device
	from <session-id>	during the specified session.
Informational	IPv6: IPv6 protocol enabled on the device	IPv6 protocol was enabled on the device
	from <session-id>	during the specified session.
Informational	MAC Filter applied to port <port-id>by	Indicates a MAC address filter was applied
	<username> from <session-id> (filter	to the specified port by the specified user
	id=<filter-ids> )	during the specified session.
		<session-id>can be console, telnet, ssh,
		web, or snmp.
		<filter-ids>is a list of the MAC address
		filters that were applied.

Informational	MAC Filter removed from port <port-id>by
	<username> from <session-id> (filter
	id=<filter-ids> )

Indicates a MAC address filter was removed from the specified port by the specified user during the specified session.

<session-id>can be console, telnet, ssh, web, or snmp.

<filter-ids>is a list of the MAC address filters that were removed.

276	Brocade ICX 6650 Administration Guide
	53-1002600-01