Christie Digital Systems CX50, CX67, CX60 user manual Power Connection, Requirements

Section 2: Source Setup

2.3 Power Connection	There are two AC receptacles on the EM. To plug in a single projector, plug the
	power cord into the top AC receptacle (labeled INLET). Then plug the 3-pronged
	end of the power cord into a grounded AC outlet.
	If you want to connect multiple projectors (up to a maximum of 4), connect a
	second power cord to the AC receptacle (labeled OUTLET) on the left side of the
	first projector and the other end to the AC receptacle (INLET) of the next
	projector. Continue connecting power cords in this manner until you reach the
	last (or 4th) projector in the chain. The last projector will have an empty AC
	receptacle OUTLET. See Figure 2.13.
		Input voltages must be capable of 100-240 VAC. Use an appropriately rated
	AC power cord with the projector. The power cord supplied is approved for
	North American use only. See Section 5, Specifications for all power
	requirements.
					WARNING
				Do not attempt operation if the AC supply and cord
			are not within the specified voltage and power range.

Figure 2.13. AC Loop

RPMX/CX50/CX60/CX67 User’s Manual 2-7